RAM Mount RAM-VB-185-SW1 - Manual

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 8410 Dallas Ave S
Seattle, WA 98108
Website: www.ram-mount.com
Email: [email protected]
Vehicle base for Ford
Specifications
Placement
Passenger side floor board, over seat frame legs
Seat Configuration
Bucket/Bench
Construction/Finish
Steel/Black Powder coat
Dimensions
Pole or Pedestal
Purchased Separately
Weight
9.4 lbs.
Tools required for base installation
Ratchet wrench, 19 mm socket, and universal joint extension for base
installation . The removal of factory seat leg bolts will require a
13/16” socket.
A = 18.15", B = 7.05", C = 3.74”
Hole Center = 11.5"
Features
Important note
Installs with no drilling required
For model year trucks 1999 through 2010, the use of the one inch
stand offs is required. For 2011 model year trucks, the tallest stand
offs are required to clear the under seat air duct in the extended cab or
crew cab models. For bench seats, it is necessary to expose the hump
side mounting hole and tap it so the supplied bolt has an anchor point.
You’ll need an M12-1.75 tap.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-185
RAM-VB-185
F-250 - F-750 Superduty trucks with
bucket seats 1999-2013, all cab
types.
RAM-VB-185-SW1