RAM Mount RAM-VB-186-SW1 - Manual

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
Vehicle base for the
SPECIFICATIONS
Placement
Passenger side, front, where seat rail frame
attaches to floor board.
Drilling Required
No
Seat Configuration
Bucket
Construction/Finish
Steel/Black Powdercoat
Dimensions
Pole or Pedestal
Sold Separately
Weight
4 lbs.
A = 17", B = 6.18", C = 1.81”
Hole Centers = 15.125”
Features
Complete Vehicle Mount
RAM-VB-186-SW1
Vehicle Base
RAM-VB-186
Installs in minutes with no drilling required
Low profile keeps mount away from passenger leg space
Lifetime warranty
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-186 & RAM-VB-186-SW1
JEEP GRAND CHEROKEE (2011-2014)
DODGE DURANGO (2011-2012)
DODGE DURANGO CITADEL (2011-2012)
National Products, Inc.
Website: www.ram-mount.com
Email: [email protected]
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
National Products, Inc.
Website: www.ram-mount.com
Email: [email protected]
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
Vehicle base for the
INSTALLATION INSTRUCTIONS
1. Move the passenger seat back to its rearmost position and remove the round plastic covers in the seat leg trim to
expose the hex bolts holding the front seat legs to the vehicle floor board. A small flat head screw driver works well
for this.
2. Using a 14MM socket, remove the factory seat leg bolts and store them along with the round plastic covers.
3. Place the supplied stand offs over the exposed holes in the seat frame legs.
4. You will need the longer bolts supplied in this kit to complete the installation. Place the flat washer over the bolts and
drop them through the holes on either end of the base. Place the base over the stand offs and align the longer bolts
with the threaded hole in the floor board. Begin threading the bolts by hand.
5. Using a 17MM socket wrench, fully tighten the bolts to secure the No-Drill™ base into the vehicle.
6. After a week of use, check seat bolts and re-tighten if necessary.
Note that not all vehicles will have the plastic trim covering the seat mounting hardware.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
JEEP GRAND CHEROKEE (2011-2014)
DODGE DURANGO (2011-2012)
DODGE DURANGO CITADEL (2011-2012)
RAM-VB-186 & RAM-VB-186-SW1