RAM Mount RAM-234-LK2 - Manual

RAM-234-LK2 TOUGH TRAY LAPTOP LOCKING KIT INSTRUCTIONS
File# ram234lk2_instructions
A
B
C
D
E
F
G
H
J
K
M
N
P
Q
R S
A. 1/4”-20 X 10 ½” LONG THREADED ROD
B. 1” X 3/4” X 9 3/8” LONG STEEL TUBE
C. 3/8” OD X 6 ½”LONG TUBE
D. SPRING
E. PLASTIC FLANGE WITH BOSE
F. PLASTIC WEDGES (2 QTY.)
G. #8-32 X 3/8” LONG MACHINE SCREW
H. 3/4” OD X 1/4” ID BLACK PLASTIC WASHER
J. #8 FLAT WASHER
K. 1/4”-20 NY-LOCK NUT
M. #8-32 NY-LOCK NUT (THICK NUT)
N. 1/4” FLAT WASHER (2 QTY.)
P. #8-32 X 1/2” LONG MACHINE SCREW (4 QTY.)
Q. #8-32 THIN NY-LOCK NUTS (4 QTY.)
R. #8-32 X 1 ½”LONG MACHINE SCREW
S. LOCKING KNOB WITH 2 QTY. KEYS
STEP 3.
INSTALL ONE END OF (D)
SPRING USING #8-32 MACHINE
SCREW & NY-LOCK NUT FROM
EXISTING TOUGH TRAY
(SCREW AND NUT NOT
INCLUDED WITH THIS KIT)
STEP 4.
ASSEMBLE THE TOUGH TRAY
MAIN SLIDE INTO THE TOUGH
TRAY MAIN HOUSING, INSERT
(R) SCREW FROM TOP
SURFACE INTO HOUSING AND
SLIDE END OF (D) SPRING
OVER (R) SCREW AS SHOWN
STEP 1.
THREAD (K) NUT ONTO (A) ROD WITH 3/8” OF (A) ROD
PROTRUDING OUT OF (K) NUT, ASSEMBLE IN ORDER,
2 QTY. (F) WEDGES, 1 QTY. (N) WASHER, (C) TUBE & 1
QTY. (N) WASHER.
NOTE: THREADS PROTRUDE 3/8”
STEP 6.
PULL TOUGH TRAY MAIN
SLIDE OUT OF MAIN
HOUSING AND WEDGE IT
AS SHOWN
STEP 5.
INSERT (B) TUBE INTO
TOUGH TRAY MAIN
HOUSING, (LARGE HOLE
MUST BE ON END WITH
SCREW) AND SLIDE IT
OVER (R) SCREW AND
GENTLY SECURE IT WITH
(M) THICK NUT NOTE:
DON’T OVER-TIGHTEN!
STEP 7.
FULLY INSERT THREADED
ROD ASSEMBLY FROM
STEP 1 INTO (B) TUBE
UNTIL IT STOPS
STEP 2.
ATTACH (E) FLANGE
TO MAIN TOUGH TRAY
SLIDE USING (P)
SCREWS & (Q) NUTS
STEP 8.
CLOSE MAIN TOUGH TRAY
SLIDE OVER (A)
THREADED ROD, INSTALL
(H) WASHER, LUBRICATE
THREADS WITH OIL OR
GREASE THEN INSTALL (S)
LOCKING KNOB INSTALL
(J) WASHER AND (G)
SCREW TO (B) STEEL
SQUARE TUBE