RAM Mount RAM-VBD-122-SW1 - Manual (Page 2)

National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [email protected]
Vehicle base for the
INSTALLATION INSTRUCTIONS
1. Place base on floor so that the pedestal is in the optimum location.
2. Mark the mounting hole locations. Please note that it might be necessary to shim a corner of the mounting base if
the floor surface is uneven.
3. Drill 17/32” holes in the floor at all of the marked locations. Be extremely careful not to damage any equipment
under the floor board of the vehicle when drilling.
4. Tighten base in place using bolts, washers, and nuts. If floor is less than 1/4” thick, please use fender washers on
the underside to help distribute the weight.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
National Products, Inc.
Item Number
RAM-VBD-122
RAM Drill Seat Bases
UNIVERSAL (ALL VEHICLES)