Baron Footrest & Controls_SPORT BOARD PASSENGER FLOORBOARDS - Manual

Page: 1 BA-7000-00
PASSENGER SPORTBOARDS - Requires Mounting Brackets
(Sold Separately)
Use caution when installing, be sure to use Locktite#&174; on all threaded
hardware. Be sure to tighten all threaded hardware prior to use.
Revision: 1.6 - 04/19/2010
Install Time: 20 Minutes
INCLUDED IN THE KIT:
Left & Right Chrome Sport Boards
(2) Chrome Pivot Mounts, pre-installed
(2) 3/8-16 x 3/4" Chrome Bolts (installed on brackets)
(2) 3/8-16 x 3/4" Chrome Bolts (installed on brackets)
INSTRUCTIONS:
NOTE: Your new floorboards come partially assembled for shipping. Please follow these simple assembly
procedures in order to install these on your motorcycle.
1. Remove the Baron Sport Boards from their packaging, you will find they come with two chrome Pivot
brackets attached. The Pivots are what allows the floorboard to attach to the mounting brackets (Sold
Separately) and how the boards tilting can be adjusted.
2. Attach the Pivot to the Floorboard Mounting Bracket using the supplied hardware that comes with the
floorboards. The larger bolts come through the back side of the mounting bracket and thread into the 3/8-16
hole in the back of Pivot, snug the 3/8" bolts up but do not tighten. Take the small 1/4-20x 1/2" Flathead Allen
screw and thread them through the small hole/s in the Pivots and into the mounting bracket.
NOTE: You must first select your preferred hole. (The upper hole will place the floorboards in a flat position
and the lower hole/s provides an angled mounting position for added comfort and control). Once selected you
may now tighten all Flathead hardware.
3. Remove stock pegs/floorboard mounts from your motorcycle.
4. The mounting brackets are left and right side specific. Install Baron mounting brackets in same holes vacated
when you removed the stock mounts using the supplied hardware.
NOTE: See specific instructions that may be included with the mounting brackets for specific instructions.
SUGGESTION: The second hole is the most preferred position.
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]