Baron Grips & Risers_DT RISERS - Manual

Page: 1 BA-7421RD
DT RISERS - Yamaha V-Star 1100 & Road Star
CAUTION! We Strongly recommend that a qualified technician install this kit
if you do not completely understand the instructions prior to the install.
Revision: 3.3 - 02/05/2010
Install Time: 60 Minutes
INCLUDED IN THE KIT:
(2) Chrome Baron DT Risers
(2) M14-2.0x65 Hex Head Bolts
(4) M6-1.25x20mm Chrome Cap Head Screws
(2) M14 Lock Washers
TOOLS REQUIRED:
5 & 6mm Allen Wrenches
Factory Service Manual
19 & 22mm Sockets
INSTRUCTIONS:
1. If your motorcycle has a windscreen, remove it.
2. Lay a thick soft towel or similar cover across the gas tank.
3. While holding the handlebar, loosen the stock riser clamps. Take care to prevent the handlebar from
dropping onto the tank.
NOTE: Loosen bolts just enough to lower the handlebars, but do not remove them.
4. Using a 19mm socket, loosen and remove the stock riser mount nuts. Turn the front wheel to its furthest
point in each direction for best access.
5. Remove the Allen bolts from the upper riser clamps and lift out the handlebar. Lay it gently across the gas
tank or have an assistant hold it.
6. Lift the stock risers out of the top triple clamp and remove the rubber damper located in the recess on top of
each riser mount. The dampers are no longer needed.
7. Using the large 14mm hex bolts and lock washers, loosely bolt on the DT Risers.
NOTE: The OEM wire guides are not compatible with your new riser hardware and must be removed or the
holes in the guide must be enlarged. On 2003 V-Star 1100 that are equipped with a factory windscreen that
attaches to the riser bolts, the holes in the windscreen bracket must be enlarged.
8. Set the handlebar in place and center it, then reattach the upper clamps. Tighten the fasteners just enough to
hold the bar in place.
9. Tighten the large hex bolts.
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]