Baron Air & Fuel_AIR INJECTION SYSTEM KIT Suzuki Models - Manual

Page: 1 BA-2580-00
PAIR Valve Removal Kit
All Suzuki Models (95 up)
This product is not DOT/EPA approved and is not for use on public highways.
This product is intended only for off-road/closed-course racing use only. This
product is intended for installation on Suzuki VL800/VL1500/VZ800 models
only. Baron accepts no responsibility for any damage incurred when installing
this product on any other motorcycle.
Revision: 1.0 - 02/19/2010
INCLUDED IN THE KIT:
(1) - 1/2" rubber cap
(1) - 1/8" rubber cap
(3) - M6x12 chrome button-head screws
(3) - Chrome flat washers
(2) - Black anodized plates
INSTRUCTIONS:
READ ALL INSTRUCTIONS PRIOR TO INSTALLATION!
1. Remove the PAIR valve cover from motorcycle for VL1500 and VZ800 it is on right side, VL800 on left
side.
2. Remove the three screws that hold back of cover assembly to engine. This will give you room to remove
hoses and pipes from engine.
3. Behind this cover is located an air supply hose - disconnect it from the PAIR valve. Dont worry if it pulls
loose from air box, it will be plugged later. On VL1500 models this hose goes up into the bottom of air box
under the false tank. On VL800 models it goes across into rear of air filter box on right side.
4. The PAIR valve is vacuum operated on most models. The vacuum line needs to be capped off with supplied
small rubber cap. Disconnect small vacuum line at T" fitting and cap off with supplied small cap. On
C-90 models, the PAIR valve is electrically operated and cannot be unplugged from the wire harness of the
motorcycle and should not be removed with the rest of the cover parts (doing so will cause your F.I. light to
stay on). You can zip-tie it up under the tank where it will not be seen or utilized.
5. Follow the steel pipes from bottom of PAIR valve to front and rear cylinders. Remove nuts (or screws)
from engine and pull pipe loose from head.
6. Now PAIR valve housing will be loose from engine and can be removed.
7. Cover the ports you removed pipes from with supplied black plates and stock nuts/screws. Make sure you
clean all of the old gasket material from mating surfaces before installation. It is a good idea to put some
sealant on the plates before installing, although they will provide a seal without this.
8. Use the supplied large rubber cap along with the stock clamp from air supply hose to cap off fitting on
either the bottom of air box on VL1500 models, or back of air box on VL/VZ800 models. On VL800 models
you may need to remove the air filter box.
9. Use supplied chrome button-head screws and washers to fill the holes vacated by removal of PAIR valve
cover.
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]