Baron Chrome Shop_OIL FILTER RELOCATION KIT Yamaha V-Star 1100 - Manual

Page: 1 BA-3100-00
TURN SIGNAL/LICENSE PLATE ASSEMBLY YAMAHA Road
Star, Royal Star, V-Star 1100 Classic
CAUTION! We Strongly recommend that a qualified technician install this kit
if you do not completely understand the instructions prior to the install.
Revision: 1.1 - 02/23/2010
INCLUDED IN THE KIT:
(4) M5x10 Chrome Allen Flat Head Screws
(4) M5x10 Stainless Steel Set Screws
(1) Rubber Base Gasket
(1) License Mount Base
(2) M5x10 Stainless Allen Flat Head Screws
(1) M6x50 Socket Cap Screw
(1) Two Piece License Plate Assembly
(2) Turn Signal Arms
TOOLS REQUIRED:
Factory Service Manual
Phillips & Flat Screwdrivers
10 & 12mm Sockets
Pliers (std. and needle nose)
10mm Open End Wrench
3, 4, & 5mm Allen Wrenches
INSTRUCTIONS:
NOTE: We recommend the use of blue Loctite on all fasteners and mounting hardware.
1. Remove license plate, reflector and associated brackets. Disconnect wires found behind license plate.
2. While supporting stock turn signal assembly, remove three mounting bolts. Slide wire harness from stock
license assembly while removing this assembly from bike. Now remove the two rubber wire grommets from
rear fender. Place supplied Rubber Base Gasket onto fender and feed wires through. Note: Green and Black
leads are for right turn signal, Brown and Black leads are for left turn signal. Reconnect tail light leads.
3. Loosen mounting bolts and remove left and right stock turn signal ends from license mount, also removing
rubber sleeve from stock turn signal ends.
4. Slide turn signal wire through new Baron Turn Signal Arm, installing longer end of arm into turn signal end.
Lightly snug turn signal end bolt/nut - do not tighten completely - final turn signal adjustment will be made
later. Repeat on other turn signal, noting left/right wire colors outlined in Step 2.
5. Insert turn signal arm assemblies into new Baron License Base and tighten set screws into arms. Note that
proper orientation of base is with set screws facing down. Now coil turn signal wires into base and connect them
to wire harness according to color codes. Next, insert supplied 6x50mm allen-head mounting bolt into license
base and carefully feed remaining wire harness into base and lower this assembly over fender gasket. Insert
mounting bolt into threaded fender hole and tighten bolt securely, making sure not to pinch or trap any wires
between base and fender.
6. Mount new License Backing Frame to base assembly with supplied flat-head allen screws (2 reqd). Install
your license plate onto Backing Frame and position new License Frame Cover Trim over license plate, noting
that notched section of Cover Trim is mounted facing down. Install remaining flat-head allen screws through
Backing Plate into Cover Trim and tighten securely.
7. Adjust each turn signal end for proper orientation and tighten bolt/nut. Test turn signal operation.
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]