Baron Grips & Risers_BLACK LINER PULLBACK RISERS Yamaha Roadliner_Stratoliner User Manual

Baron For motorcycles

Advertising
background image

Page: 1

BA-7422-00
LINER PULLBACK RISERS - Yamaha Roadliner & Stratoliner

Revision: 2.5 - 05/25/2012

Install Time: 60 Minutes

INCLUDED IN THE KIT:

(2) Baron Pullback Risers

(2) 3/8"-16 x 5" Socket Head Cap Screws

(2) 3/8"-16 Nylock Nuts

(2) 3/4" Spacers

(2) Zinc Washers

TOOLS REQUIRED:

5/16" Allen Wrench

5/16" Open-End Wrench or Socket

Towels/Tank Protector

6mm Allen Wrench

17mm Open-End Wrench or Socket

Factory Service Manual

INSTRUCTIONS:

Thank you for purchasing Baron Liner Pullback Risers! Installation is reasonably simple providing you follow
the instructions below implicitly. As always, please read the instructions in full prior to installing the product. If
you feel you dont understand it, please call our tech support line, or have the product installed by a competent
technician. This install is best performed by two people, have a helper handy to make it go smoothly!

FUEL TANK ADJUSTMENT:
The first step before beginning your riser install is to make the following adjustment to your tank position. This
is very important, as a mis-adjusted fuel tank can cause contact between the LinerRiser and the chrome dash
cover. This portion of the install takes approximately 5 minutes. Follow these instructions; do not loosen any
additional bolts other than the ones mentioned.

1. Remove chrome dash by removing (3) 5mm allen head bolts and disconnecting the (3) electrical connectors.
Then lift cover and speedometer off and away from bike.

2. Check to see if your tank is adjusted to the rear-most position (as seen in photo #2). If it is then you can
re-install the dash (be sure to connect the electrical leads) and proceed with the riser install.

If the tank mount appears to be adjusted as seen in Photo #1 above, then please follow these directions:

Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or

fitment may be required. Barons bears no responsibility on installation costs associated with this product.

© 2013 Barons Custom Accessories

5221 Oceanus Drive

Huntington Beach, CA 92649

(925)583-2499 - Ph.

(714)901-0520 - Fax

www.baronscustom.com

[email protected]

Advertising