Baron Air & Fuel_xXx BIG AIR KIT VTX 1800 BLACK - Manual

Page: 1 LA-2360-00 & LA-2360-00B
xXx BIG AIR KIT (BAK)
HONDA VTX 1800
CAUTION! We Strongly recommend that a qualified technician install this
kit if you do not completely understand the instructions prior to the install.
Revision: 1.7 - 03/18/2013
Install Time: 30 Minutes
INSTRUCTIONS:
1. Remove fuel tank per Honda service manual instructions.
2. Remove air filter box by taking out air filter element and the 4 screws around air funnels.
3. Disconnect electrical fitting from the IAT sensor (intake air temp sensor).
4. Disconnect two hoses on back of air box. The smaller hose is the crank case vent hose, the larger is the
fresh air supply to the PAIR system. If the PAIR system is removed, cap this with rubber cap supplied.
5. Remove IAT sensor from back of air box and install it onto new backing plate with supplied M5x10
screws. Set stock air box aside - you will not need it anymore.
6. Install backing plate adapter onto throttle body with supplied M5x40 screws and factory o-ring (flat side
facing out away from engine).
7. Install three stand-offs onto new back plate using three 1/4-20x3/4" Black Flat Head Allen Screws.
8. Install 3/8" & 1/2" Hose Barbs into the back of the xXx BAK Back Plate. Be careful not to overtighten.
9. Install backing plate onto adaptor you have already installed on throttle body using supplied M6x16 bolts.
Be sure to use the supplied gasket between the adapter and the back plate. As you are installing the
backing plate, reconnect the two hoses and electrical fitting removed in previous steps.
NOTE: If you have removed the PAIR system you will need to cap the larger fitting on backing plate.
10. Place filter over the spacers and into the groove on backing plate. Place cover plate onto filter. Gently
guide the cover plate around filter to seat and seal filter. Insert three 1/4-20x3/4" Black Flat Head Allen
Screws onto spacer mounts.
11. Using the 1/4-20x1/2" polished SS Flat Head Allen, attach mesh & xXx cover to black cover. Torque to 5
ft.lbs.
12. Re-install fuel tank.
We recommend the use of an EFI modifier when the xXx BAK is installed with aftermarket exhaust. Stock exhaust
should not require an EFI map.
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. LA Choppers bears no responsibility on installation costs associated with this product.
© 2013 LA Choppers
5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.lachoppers.com [email protected]