Baron Chrome Shop_SIDE MOUNT LICENSE - Manual

Page: 1 BA-3103-00
SIDE MOUNT LICENSE - Universal Fitment (Mounting bracket
required)
CAUTION! We Strongly recommend that a qualified technician install this kit
if you do not completely understand the instructions prior to the install.
Revision: 1.8 - 02/08/2010
Install Time: 60 Minutes
INCLUDED IN THE KIT:
(1) Complete Chrome License Mount w/Cat-Eye Brake
Light
INSTRUCTIONS:
NOTE: This part requires a mounting bracket sold separately
IMPORTANT: Please read ALL of the instructions BEFORE beginning the installation.
NOTES: Your new Side Mount License comes partially assembled for shipping. Please follow these simple
assembly procedures prior to mounting the unit to your motorcycle.
ASSEMBLY
1. Remove four (4) license plate frame mount screws and the license plate frame from your new Baron
License/Tail Light assembly.
2. Attach backing plate to the mounting bracket with supplied 6x10mm screws
3. Position license plate and install plate frame. Tighten remaining screws.
INSTALLATION
1.Wire the tail light into motorcycles wire harness as follows: (Brake light): Taillights red wire to
motorcycles brake light wire. (Tail/running light): Taillights yellow wire to motorcycles running light wire.
Black wire to ground. You will need approximately 30-inches of wire to properly route taillight wiring up swing
arm and into wire harness.
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]