Baron Lighting & License_ULTIMATE LIGHT BAR - Manual

Page: 1 BA-3006-00
ULTIMATE LIGHTBAR - Universal Fitment
Use Blue Loctite® on all hardware. Refer to owner's manual for any removal
questions related to the stock headlight assembly and electrical.
Revision: 9.3 - 08/11/2011
Install Time: 120 Minutes
INCLUDED IN THE KIT:
(2) M6x16 Hex Bolts
(2) Rubber Cone Washers
(2) 3/8" Tooth Washers
(2) M8 Flat Washers
(2) 3/8" Flat Washers
(2) 1/4" Rubber Washers
(2) M8x35 Chrome Allen Cap Bolts
(2) Hollow Hex Bolts Short
(2) Hollow Hex Bolts Long
(2) L" Brackets
(1) Reinforcement Bracket
(2) Long Aluminum Spacers Threaded one end
(2) Short Steel Spacers
(1) Mini Switch (optional)
(5) Male Bullet Connectors w/Covers
(2) Female Spade Connectors w/Covers
(6) Butt Connectors
(2) Poly Tubing Sleeves
INSTRUCTIONS:
Your new Ultimate Light Bar comes with everything you need to install on the following bikes: Yamaha Road
Star, V-Star 1100 Classic, Royal Star (96~01); Kawasaki VN1500 Nomad, VN1600 Classic/Nomad, VN2000;
Honda VTX1300 Retro, VT750 ACE; Suzuki Boulevard C-50 & C-90; and may fit others not specifically listed.
Step 1 (for all installations): Removal of stock turn signals and holder:
Disconnect battery.
Remove headlamp bezel.
Disconnect the turn/running light wires noting the wire colors for later reconnection.
Remove turn signal bar from motorcycle (except VN1500 Nomad - it can be installed on bike).
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]