Whirlpool ARG341A+ - Manual (Page 11)

11
Failure to follow the instructions regarding
sanitizing can compromise the hygienic safety
of the water dispensed.
• When using the appliance for the first time and
every time the filter is changed, discard the first
9-14 litres of water, equivalent to 6-7 minutes of
dispensing (not necessarily consecutive, but
before initial consumption) and discard the ice
produced in the first 24 hours.
• If the water dispenser has not been used for
more than 4/5 days, it is advisable to clean the
circuit and run off the first litre of water.
• Reposition the removable water dispenser (if
present), ensuring your hands are hygienically
clean.
• Clean the ice bucket or drawer regularly but
using only drinking water.
• The filter must be changed when indicated on
the control panel or when the ice/water
dispenser has not been used for more than 30
days.
• With each filter replacement, sanitise the ice
and/or water distribution system using a food
grade disinfectant (with sodium hypochlorite),
which does not alter the characteristics of the
materials, or use the "Sanitising Kit" available
from the After-Sales Service. Rinse with at least
2 litres of water before use.
• Only original spare parts supplied by the
manufacturer should be used when replacing
components in the ice and water dispenser.
• Any work on the appliance must be carried out
by a qualified technician or the After-sales
Service.
CLEANING, SANITIZATION AND
MAINTENANCE OF THE ICE AND/OR
WATER DISPENSER
(if present)
INSTALLATION
• The appliance must be
handled and installed by
two or more persons.
• Be careful not to
damage the floors (e.g. parquet) when moving
the appliance.
• During installation, make sure the appliance
does not damage the power cable.
• Make sure the appliance is not near a heat
source.
• To guarantee adequate ventilation, leave a space
on both sides and above the appliance and
follow the installation instructions.
• Keep the appliance ventilation openings free.
• Do not damage the appliance refrigerant circuit
pipes.
• Install and level the appliance on a floor strong
enough to take its weight and in a place suitable
for its size and use.
• Install the appliance in a dry and well-ventilated
place. The appliance is arranged for operation in
places where the temperature comes within the
following ranges, according to the climatic class
given on the rating plate. The appliance may not
work properly if it is left for a long time at a
temperature outside the specified range.
• Make sure the voltage specified on the rating
plate corresponds to that of your home.
• Do not use single/multi adapters or extension
cords.
• For the water connection, use the pipe supplied
with the new appliance; do not reuse that of the
previous appliance.
• Power cable modification or replacement must
only be carried out by qualified personnel or by
After-sales Service.
• It must be possible to disconnect the appliance
from the power supply by unplugging it or by
means of a mains two-pole switch installed
upstream of the socket.
SAFETY
• Do not store explosive substances such as
aerosol cans with a flammable propellant in this
appliance.
• Do not store or use petrol, flammable liquids or
gas in the vicinity of this or other electrical
PRECAUTIONS AND GENERAL
RECOMMENDATIONS
Climatic Class Amb. T. (°C) Amb. T. (°F)
SN From 10 to 32 From 50 to 90
N From 16 to 32 From 61 to 90
ST From 16 to 38 From 61 to 100
T From 16 to 43 From 61 to 110