Model msd media monitor, Wiring connections, Specifications – Electronics MSD User Manual

Page 2

Advertising

* MODEL MSD MEDIA MONITOR *

Wiring Connections

67.1mm

135.9mm

144mm

72.1mm

228.6mm

1. Power Neutral (120Vac)

. High Alarm Relay Contact

6. High Alarm Relay Contact
7. Low Alarm Relay Contact
8. Low Alarm Relay Contact
9. Alarm Reset (120Vac)
11. (+) 12Vdc Excitation Output
12. (-) 12Vdc Excitation Output
13. (+) 5vdc Reference
14. 0-5 Vdc Input
15. 0 Vdc
16. Sensor Shield
19. 0 Vdc
20. Recorder Output (0-10Vdc)

2. Power Hot (120Vac)
3. Enable Input (120Vac)
4. Earth Ground
5

1. Power Neutral (120Vac)

. High Alarm Relay Contact

2. Power Hot (120Vac)
3. Enable Input (120Vac)
4. Earth Ground
5

NOTE:
Green screw for
earth-chassis ground
used for shield termination.

56790 Magnetic Drive Mishawaka, IN. USA 46545 (574) 256-5001

All adjustments available

behind front panel access plate

All adjustments available

behind front panel access plate

PANEL

CUTOUT

S:\COREL\DRA

W\DA

ASHT\MSD1.CDR

7/29/99

Note: All views shown with front access plate removed

MOUNTING INSTRUCTIONS

PANEL CUT-OUT IS 5.35“ X 2.64” ( 135mm X 67mm )

PANEL CUT-OUT

6-32 SET SCREWS

TOP RAIL

BOTTOM RAIL

ALLEN HEAD

SCREWDRIVER

NOTE: CONNECTORS ARE
REMOVABLE FOR SERVICE

WARNING: DO NOT REMOVE

FACE PLATE OR BEZEL

1. REMOVE TOP AND BOTTOM SLIDE RAILS FROM UNIT

2. SLIDE CONTROLLER INTO PANEL FROM FRONT

3. SLIDE RAILS BACK INTO CONTROLLER AND TIGHTEN

USING SET SCREWS.

MOUNTING STEPS

EA0501Z.CDR 2-6-98

830228.A

Specifications

Power: 120Vac, 50/60 Hertz, 50VA

Inputs:

0 - 5vdc Analog Voltage

Alarm Reset: 90-120Vac

Media Sensor:

Enable: 90 - 120Vac

Outputs:

Recorder output: 0-10Vdc Analog Voltage

Alarm Contacts: Voltage free normally open contacts

rated at 120Vac @ 1Amp max

Excitation Voltage: +/- 12Vdc (100mA)

Weight: 1.4 kg

Display: 20 Segment Bar Graph