Electronics AC-24 - Manual

AC-24 Controller
MagnaValve® Motor Current Controller
Features
• Monitors motor current
• Four-digit display
• 10 LED bar graph
• High-low alarm contacts
• Accepts remote command setpoint
• Provides analog recorder output
• Easy panel mounting (1/2 DIN)
• Provides automatic operation (a closed loop system)
for the LP-24, VLP-24 and WM 3000-24 MagnaValve®
• 24 Vdc
Description
The AC-24 Controller provides automatic operation (a closed-loop system) for the MagnaValve®. The
feedback from the controller allows the MagnaValve to regulate steel shot in shot peening and blast
cleaning applications where accurate and repeatable flow rates are desired. The controller may operate
as a stand-alone control or work with a customer’s programmable controller via standard analog 0-10 Vdc
interface.
A clear and comprehensive installation manual simplifies installation for the AC-24 Controller and the
product is supported by the Electronics Inc. application engineering staff.
Electronics Inc.
56790 Magnetic Drive
Mishawaka, Indiana 46545 USA
(574)256-5001
www.electronics-inc.com
Specification is subject to change without notice
Rev3 3/12
MagnaValve is a registered trademark of Electronics Inc.
AC-24
Controller
Regulated Media Flow
Control Signal
Desired
Motor Current
Motor
Current
Ammeter
Media Accelerated
Media
Hopper
MagnaValve
Wheel
Available for download at www.electronics-inc.com
LP-24 data sheet VLP-24 data sheet
WM 3000-24 data sheet AC-24 Installation Manual
The Closed Loop System
with the AC-24 Controller and a MagnaValve