Peerless Water 30 CME Series - Service Manual - Manual (Page 8)

CONTROL PROGRAMMING CONTINUED
SET TIME OF DAY
The user can also set the time of day. Time of day should only need to be set after extended power outages or when
daylight savings time begins or ends. If an extended power outage occurs, the time of day will flash on and off which
indicates the time of day should be reset.
STEP 1U – Press SET CLOCK
STEP 2U – Current Time (hour): Set the hour of the day using the down or up arrow buttons. AM/PM toggles after
12. Press NEXT to go to step 3U.
STEP 3U – Current Time (minutes): Set the minutes of the day using down or up arrow buttons. Press NEXT to exit
Set Clock. Press REGEN to return to the previous step.
POWER LOSS: If the power goes out for less than two hours, the system will automatically reset itself. If an
extended power outage occurs, the time of day will flash on and off which indicates the time of day should be reset.
The system will remember the rest.
ERROR MESSAGE: If the word “ERROR” and a number are alternately flashing on the display, contact Peerless, Inc.
@ 269-344-6137 for help. This indicates that the valve was not able to function properly.
SANITIZING THE SYSTEM
1. At completion of softener installation, you should sanitize the system.
2. Take the lid off the brine (salt) tank and then take the cap off of the brine well. Pour about ½ cup of 5.25%
unscented household bleach into the brine well. Replace cap and lid. (This can be done with or without salt in tank.)
3. Press and hold regeneration button to start the regeneration process immediately.
Each water softener is handled in a manner to keep clean and sanitary. The materials used will not contaminate your
water supply or cause bacteria to grow. However, during shipping, storage, installation, and operation, bacteria
growth could develop. Some water supplies may need periodic disinfecting.