Speedhut Fuel Level Sender - Manual

To Chassis
Ground
SEND
-
+
To Power
+12 Volts
You need to supply 12volt
power to the sensor.
To Gauge
For Speedhut gauges with single sensor wire
To Gauge
Ground
SEND
-
+
To Power
+12 Volts
You need to supply 12volt
power to the sensor.
To Gauge
Default Revolution and Legacy fuel level gauge is 240Ω (Empty) - 33Ω (Full) Ohms Equivalent
For Revolution and Legacy gauges with included ground wire in harness
Fuel Level Sender Instructions
WARRANTY - Speedhut inc. warrants to the consumer for a period of 5 years from the date of purchase that the product will be free from defects in materials or workmanship.
Speedhut warrants to the consumer for a "LIFE-TIME" that the gauge circuit board will be free from defects in materials or workmanshipPlease contact Speedhut service dept.
If you have a problem with this gauge. [email protected]
72°
68°
80°
68°
Ø 2.125
Fuel Level Bolt Hole Pattern
No Gauge Calibration Necessary (Sender is 240Ω Empty 33Ω Full)
Default Speedhut fuel level gauge is 240Ω (Empty) - 33Ω (Full) Ohms Equivalent
No Gauge Calibration Necessary (Sender is 240Ω Empty 33Ω Full)
Fuel Level sender will automatically calibrate full on first fill up.
DO NOT TEST IN ANY OTHER FLUID BESIDES GASOLINE AND DIESEL FUEL.
Testing the sender unit in any other fluid will damage the unit.