Speedhut 1995-1999 Mitsubishi Eclipse Dual Cluster Pod - Manual

Please contact Speedhut service department If you have a problem with this Product.
Speedhut Inc. 165 North 1330 West B2, Orem, Utah 84057 | [email protected] | (801) 221-1460 (9am - 5pm MST) | www.Speedhut.com
Please contact Speedhut service department If you have a problem with this Product.
Speedhut Inc. 165 North 1330 West B2, Orem, Utah 84057 | [email protected] | (801) 221-1460 (9am - 5pm MST) | www.Speedhut.com
Model# 20012 (grommets and screws)
Removal of Factory bezel:
1. Remove both screws from top of factory bezel.
2. Pull straight out on the bottom of the bezel to release clips. Pull on one side of the bezel at a time (to the left and right
side of the steering wheel).
Installation of Gauge Pod:
1. Press white grommets into the dash in the same location as the factory clips would snap in.
2. Install gauges in pod (Gauges are a press fit).
3. Install gauge pod using factory screws in the top and install provided screws in the bottom.
Note: Tighten lower screws enough to hold the pod against the dash. Over tightening will pull grommets from dash.
Model# 20012 (grommets and screws)
Removal of Factory bezel:
1. Remove both screws from top of factory bezel.
2. Pull straight out on the bottom of the bezel to release clips. Pull on one side of the bezel at a time (to the left and right
side of the steering wheel).
Installation of Gauge Pod:
1. Press white grommets into the dash in the same location as the factory clips would snap in.
2. Install gauges in pod (Gauges are a press fit).
3. Install gauge pod using factory screws in the top and install provided screws in the bottom.
Note: Tighten lower screws enough to hold the pod against the dash. Over tightening will pull grommets from dash.
Installation Instructions: Mitsubishi Eclipse 95-99 - Dual Cluster Pod
Installation Instructions: Mitsubishi Eclipse 95-99 - Dual Cluster Pod