Speedhut 3-3_8 inch, 4 inch, & 4-1_2 inch Speedometer - Manual (Page 2)

Peak recall (optional feature)
Calibrate speedometer
1. With speedometer powered up press and release button to display menu
2. Press and release button until trip icon is selected
3. Press and hold for 2-3 seconds to select and clear trip icon.
Trip reset
TRIP
0
B/W
PPM
PPM
1. With speedometer powered up press and release button to display menu
2. Press and release button until B/W icon is selected
3. Press and hold for 2-3 seconds to inert contrast of screen.
Invert contrast
WARRANTY - Speedhut inc. warrants to the consumer for a period of 5 years from the date of purchase that the product will be free from defects in materials or workmanship.
Speedhut warrants to the consumer for a "LIFE-TIME" that the gauge circuit board will be free from defects in materials or workmanship. Please contact Speedhut service dept.
If you have a problem with this gauge. [email protected]
Speedometer Instructions
Note: If your speedometer has a jack button then plug it into back of the speedometer.
To start calibration you will need to start from the odmeter/trip screen
1. With speedometer powered up press and hold the button for 10-12 seconds.
Note: Keep holding the button past the Peak Recall if your gauge has that option.
2. Press and release button until the selection box is around the PPM icon (PPK for km/h models). The icon looks like a straight road.
3. Press and hold the button for 2-3 seconds to access PPM(PPK for km/h models) Calibration Mode.
4. LCD will prompt you to press button to start calibration.
Note: Starting Calibration can be done while driving or while parked.
5a. Drive to mile marker and then press and release button to start calibration.
5b. Drive 2 miles (4 kilometers) from the mile marker and promptly press and release the button to complete the calibration.
6. Calibration is completed. The Speedometer will exit Calibration Mode automatically and begin reading MPH(KM/H) and mileage.
The Speedometer is designed to work with any wave/pulse form from 1 volt - 100 volts. Pulses per mile from 500 - 250,000.
If your speedometer is not accurately showing MPH, double check your sensor wiring.
00000 0
000000
MI
MI
If your speedometer has peak recall you can see your top speed by pressing and holding the button for 2 seconds. Then the LCD will display peak MPH(KM/H).
After releasing button, press again within 2 seconds to clear peak memory. Speedometer is now ready to store another peak.