Speedhut 2-1_16 inch Speedhut Series - Manual

2-1/16" Gauge Instructions
Ground
+12 volts Dash lighting
(Yellow)
snap connector for dial lighting
Voltage Gauge
voltage source
to be measured
Pressure Gauges
Temperature Gauges
1.Disconnect negative (-) Battery Cable
2.Connect wiring as above.
3.Mount Gauge for easy viewing. Use spin lock ring (included) to mount to panel. Spin ring
threads in both directions (depending on your dash panel thickness). Snap Gauge connector to wiring connector
4.Reconnect negative (-) battery cable.
+12 volts keyed ignition (Red)
(Black) Ground
(White) +12 volts Dash lighting
Note: Tie both lighting white wires together
and both black ground wires together.
Ground
+12 volts Dash lighting
snap connector for dial lighting
+12 volts keyed ignition (Red)
(Black) Ground
(White) +12 volts Dash lighting
Ground
+12 volts Dash lighting
snap connector for dial lighting
+12 volts keyed ignition (Red)
(Black) Ground
(White) +12 volts Dash lighting
Note: Gauge sensor must be grounded to
sealing compound on threads.
INVERTER
Note: Gauge sensor must be grounded to the
tape.
WARRANTY - Speedhut inc. warrants to the consumer for a period of 5 years from the date of purchase that the product will be free from defects in materials or workmanship.
Speedhut warrants to the consumer for a "LIFE-TIME" that the gauge circuit board will be free from defects in materials or workmanship. Please contact Speedhut service dept.
If you have a problem with this gauge. [email protected]
Note: Tie both lighting white wires together
and both black ground wires together.
(Pointer (needle) lighting)
(Main gauge power)
(Gauge Dial lighting)
Note: Tie both lighting white wires together
and both black ground wires together.
(Pointer (needle) lighting)
(Main gauge power)
(Gauge Dial lighting)
Note: Tie both lighting white wires together
and both black ground wires together.
(Pointer (needle) lighting)
(Main gauge power)
(Gauge Dial lighting)
INVERTER
INVERTER
(Yellow)
(Yellow)
Power Draw = 0.2 Amp
5 Amp Inline Fuse Recommended
for +12 Keyed Ignition
Power Draw = 0.2 Amp
5 Amp Inline Fuse Recommended
for +12 Keyed Ignition
Power Draw = 0.2 Amp
5 Amp Inline Fuse Recommended
for +12 Keyed Ignition
Inverter Note: INVERTER IS REQUIRED FOR GAUGE DIAL LIGHTING. E18-686-5CR is
single gauge inverter to light single gauge. C01-18N-2 and C11-18A01 are multiple
gauge lighting inverters that can light up to 6 - 8 gauges depending on inverter model.
See Inverter Note
See Inverter Note
See Inverter Note