Turbosmart BOOST CONTROLLERS – ELECTRONIC - Dual LED ring for e-Boost2 - Manual

1
------------------------------------------------------------------------------------------------------------------------
IMPORTANT NOTES ON YOUR DUAL LED MOUNT
•
LEDS AND CABLES ARE NOT SUPPLIED AND MUST BE PURCHASED SEPERATELY. FOUR DIFFERENT COLOUR LEDS
ARE AVAILABLE, RED, ORANGE, GREEN AND BLUE.
• THE DUAL LED ACCESSORY IS DESIGNED TO WORK BY PLUGGING INTO THE E-BOOST2 ONLY. CONNECTING THE
LEDS TO ANY OTHER DEVICE (E.G. 12V POWER) WILL BLOW THE LED.
-------------------------------------------------------------------------------------------------------------
HOW TO INSTALL YOUR DUAL LED MOUNT
Please check that the following items have been provided with your Dual LED Ring Mount.
ITEM
NO.
DESCRIPTION Quantity
1 LED CLAMP RING 1
2 LED NUT 2
3 LED BUSH 2
4 M2 GRUB SCREW 2
5 1.5 mm ALLEN KEY 1
6 4 WAY MALEPLUG 1
7 O-RING -7mm I.D x 2.0 C.S 2
ASSEMBLING YOUR RING LED MOUNT
1. The two bushes (3) will come pre-installed on the ring mount.
2. Insert the cable attached to the led (not supplied) through the o-ring (7) and led nut. Repeat the procedure for the other cable.
3. Screw the led nut (2) onto the led bush (3). Repeat the procedure for the other led nut and led bush.
4. Insert the clips at the end of the cable into the 4 way male plug, making sure the blue wire is on top and the white at the
bottom as shown in detail.
5. Screw on the two grub screws (4) onto the ring mount using the 1.5mm Allen key supplied. It is recommended that loctite be
used to secure the screws.
6. Slide the ring mount over the e-boost from the back until it touches the back of the bezel.
7. Position the ring mount as desired.
8. Connect male plug into 4 way female plug in the back of the e-boost2.
Product Name: Dual LED mount
Product Description: Dual LED mount Kit
Product Number:
TS-0301-2006, TS-0301-2007, TS-0301-2017, TS-0301-2018
6
4
1
3
2
7
LED shown but not
supplied
Cable shown but not
supplied
3
3
White wires
on bottom
row Barbs
Barbs Blue wires
on top row
Tabs
Note: Plug wires into male plug with tabs
facing up & barbs facing sideways as
shown. Ensure that the correct wires for
each corresponding LED are inserted in
the correct pin holes on the male plug.
Tabs
MALE
PLUG
Detail Plug
Connection
LED 2 on e-boost 2
menu
LED 1 on e-boost2
menu