Turbosmart BOOST CONTROLLERS – ELECTRONIC - e-Boost2 (2005-current) – Quickstart Guide - Manual

e-Boost 2 QUICK START GUIDE
Wiring
- The e-Boost2 must be connected to a 12 volt negative earth electrical system.
- All electrical connections must be soldered.
- Refer to the following table and diagram for detail on wiring the e-Boost2.
Wire Connect to
RED + 12 Volts switched through ignition – connect via 5 Amp fuse supplied
BLACK Chassis, earth or ground
GREY Solenoid wire 1 – connect using wire supplied – polarity not important
BROWN Solenoid wire 2 - connect using wire supplied – polarity not important
YELLOW RPM signal from ECU or negative terminal of an ignition coil
WHITE Auxiliary output – switched to ground – see diagram below
GREEN External set point switching
ORANGE External set point switching
Solenoid hook up method (Basic setup)
Internal wastegate setup: Port 1 (Vent), Port 2 (Internal wastegate actuator), Port 3 (Pressure only)
External Wastegate setup: Port 1 (Vent), Port 2 (Bottom port of wastegate), Port 3 (Pressure only)
For advanced hook up methods, please read the complete E-Boost 2 manual
1) Enter Setup menu by pressing MODE and SETUP/UP at the same time.