Turbosmart BOV ADAPTERS - Nissan Skyline R32 Plumb Back - Manual

SKYLINE R32 GTS-T PLUMB BACK KIT INSTRUCTIONS
Head Office: Turbosmart Pty Limited, PO Box 264 Croydon, NSW, 2132 Australia Ph: +61(2) 9798 2866 Fax: +61 (2) 9798 2826 Email: [email protected]
USA Office: Turbosmart USA, 1185 Park Center Drive, Suite Q, Vista CA 92081 USA Ph: (760) 727 7610 Fax: (760) 727 7963 Email: [email protected]
PART NUMBER
FG-ADM-R32PBK
IMPORTANT NOTES ON FITTING YOUR SKYLINE R32 BOV PLUMB BACK KIT
Turbosmart recommends that your Blow Off Valve (BOV) and Adaptor kit is fitted by an appropriately qualified technician.
IMPORTANT! You will also need the following adaptor kit for this Plumb Back or Dual Port BOV installation:
Adaptor Kit Name Part No.
Skyline R32 Adaptor Kit FG-ADM-R32
ADAPTOR KIT CONTENTS
Please check that the following items have been provided in your R32 Plumb Back Kit.
Qty Description Use
1 32mm ID Silicon bend assembly Used to connect the BOV plumb back fitting with the factory plumb back hose
2 40mm hose clamps Secures the Silicon bend assembly to the BOV plumb-back fitting and factory return pipe
Note: This R32 Plumb Back Kit accepts the following Turbosmart BOVs:
Blow Off Valve Name Part No.
Blow-off Valve - Plumb Back FG-BOV-003PB32
Blow-off Valve - Dual Port FG-BOV-003DP32
FITTING YOUR BOV R32 PLUMB BACK KIT
Note: Please thoroughly read and understand these instructions, the Skyline R32 Adaptor instructions and the fitting
instructions supplied with your BOV before commencing this installation. These instructions follow on from Step 6 of
the R32 Adaptor instructions included with the R32 BOV Adaptor Kit.
Step 7. Install your Turbosmart BOV onto the R32
Adaptor by following the instructions included with the
BOV. Step 8. Install the preassembled Silicon bend as
shown in the diagram below:
Step 8. Connect the preassembled Silicon bend to the
BOV fitting and factory plumb back fitting:
Step 9. Connect one end of the Silicon bend to the
BOV plumb back fitting and the other end of the Silicon
bend to the factory return pipe. Secure each fitting with
the a 40mm hose clamp supplied.
90mm
Connect to Factory
Return Pipe
Connect to BOV
Plumb Back
fitting
72mm
87mm
80mm
64mm
90° hose and 45°
hose are offset by
an angle of 135°
Connect to BOV
Return Pipe
Connect to
BOV fitting