Turbosmart WASTEGATES – EXTERNAL - Hyper-Gate45 (with locking ring) - Manual (Page 3)

www.TURBOSMARTONLINE.com
3
MOUNTING
For the best results, an attempt should be made, if space allows, to mount the Hyper-Gate45 at an angle to the exhaust flow to allow for
better flow. See the schematic diagrams below for examples of mounting positions.
SPARE PARTS AND ACCESSORIES LIST
TS-0504-3001: WG45 Inlet weld flange
TS-0504-3002: WG45 Outlet weld flange
TS-0504-3003: WG45 Valve seat
TS-0504-3004: WG45 Inlet V-Band
TS-0504-3005: WG45 Outlet V-Band
TS-0505-3006: WG38/40/45 Diaphagm assembly
TS-0505-3007: 74mm Locking collar
TS-0505-3008: 74mm Collar tool
TS-0505-3009: 1/16TH NPT - 6mm barb vacuum fittings
TS-0505-2007: 1/16TH NPT - 1/8 NPT Female fittings
TS-0505-2008: 1/16TH NPT - -3AN Flare fittings
TS-0505-2009: 1/16TH NPT - -4AN Flare fittings
ACHIEVING YOUR TARGET BOOST PRESSURE
There are various factors involved in achieving your target boost pressure including.
- The size of the spring fitted in your wastegate i.e. the boost pressure achieved by the wastegate spring only.
- The desired level of boost pressure and the difference between this and your wastegate spring pressure.
- The size of your turbocharger and wastegate and the resulting exhaust manifold backpressure in your system.
Turbosmart recommends the ideal setup for achieving your target boost pressure is to use the Hyper-Gate45 in conjunction
with a Turbosmart e-Boost controller.
Best flow – shallow
mount angle
Good flow – slight
mount angle
Turbine
Exhaust gas flow
from engine
Exhaust gas flow
to wastegate
Wastegate
Wastegate
Turbine
Exhaust gas flow
to wastegate
Exhaust gas flow
from engine
Exhaust gas flow
from engine
Turbine
Turbine
Exhaust gas flow
from engine
Exhaust gas flow
to wastegate
Exhaust gas flow
to wastegate
Poor flow – 90
degree mounting
Not recommended – less
than 90 degree mounting