Turbosmart BOV ADAPTERS - Subaru Forester 2.0 User Manual

0l gt forester blow-off valve adaptor instructions, Step 1. locate the factory bov, Remove e

Advertising
background image

2.0L GT FORESTER BLOW-OFF VALVE ADAPTOR INSTRUCTIONS

Head Office: Turbosmart Pty Limited, PO Box 264 Croydon, NSW, 2132 Australia

Ph: +61(2) 9798 2866

Fax: +61 (2) 9798 2826

Email:

[email protected]

USA Office: Turbosmart USA, 1185 Park Center Drive, Suite Q, Vista CA 92081 USA

Ph: (760) 727 7610

Fax: (760) 727 7963

Email:

[email protected]

PART NUMBER
FG-ADM-FRST20

IMPORTANT NOTES ON FITTING YOUR BOV 2.0L GT FORESTER ADAPTOR
Turbosmart recommends that your Blow Off Valve (BOV) and Adaptor kit is fitted by an appropriately qualified technician.

ADAPTOR KIT CONTENTS
Please check that the following items have been provided in your 2.0L GT Forester adaptor Kit.

Qty

Description

Use

1

2.0L GT Forester Adaptor

Designed to specifically fit to the Forester’s intercooler

1

Flange Gasket

For fitment between the intercooler and the Forester adaptor

1

29mm Blanking Plug

To seal the factory return hose

1

450mm Length of 5mm Vacuum Hose

Connects Blow-Off-Valve to the intake manifold fitting

1

6mm hose spring clamp

Secures the 6mm end of the Silicon hose assembly to engine manifold fitting

1

5mm hose spring clamp

Secures the 5mm end of the Silicon hose assembly to the Turbosmart BOV

Note:

This Forester Adaptor readily accepts the following Turbosmart BOVs:

Blow Off Valve Name

Part No.

Blow-off Valve - Vee Port

FG-BOV-002VP

Blow-off Valve - Supersonic

FG-BOV-003SS

Blow-off Valve – Dual Port

FG-BOV-003DP29

Blow-off Valve – Plumb Back

FG-BOV-003PB29

FITTING YOUR BOV GT FORESTER ADAPTOR

Note: Please thoroughly read and understand both these instructions and the fitting instructions supplied with your
BOV before commencing this installation.

Step 1. Locate the factory BOV.

Step 2. Using a 12mm socket or spanner, undo the
two nuts securing the factory BOV. Remove the hose
clamp securing the return hose and disconnect the
return hose from the factory BOV.

Step 3. Disconnect the two vacuum/boost lines
connected to the factory BOV.

Step 4. Remove the factory BOV and old factory
gasket.

REMOVE
E

REMOVE

REMOVE

Undo

Factory

BOV

Advertising