Turbosmart BOOST CONTROLLERS – ELECTRONIC - Roll Cage Mount for e-Boost2 - Manual

1
------------------------------------------------------------------------------------------------------------------------
IMPORTANT NOTES ON YOUR SINGLE LED MOUNT
•
This product is specifically designed to hold the 60/66mm e-boost. It can however be used to secure your gauges of 60/66mm
construction. The mount is designed to suit roll cage bar diameters from 1.5” to 1.75”.
-------------------------------------------------------------------------------------------------------------
HOW TO INSTALL YOUR ROLL CAGE MOUNT
Please check that the following items have been provided with your roll cage mount.
ITEM
NO.
DESCRIPTION Quantity
1 60/66mm DASH MOUNT CLAMP 1
2 BUTTON HEAD CAP SCREW 2
3 ROLL CAGE MOUNT SPACER 2
4 ROLL CAGE MOUNT BASE 1
5 ROLL CAGE MOUNT SWIVEL 1
6 STAINLESS STEEL 32-50mm CLAMP 2
1. Place the swivel (5) inside the base (4), making sure the threaded hole of the swivel lines up with the slot in the base.
2. Line up the holes on the clamp to the holes on the swivel.
3. Insert the spacer (3) between the clamp and base and push the button head cap screw (2) through the clamp, spacer and
base.
4. Using a 4mm allen key, tighten the screw into the swivel with loctite applied to the screw thread.
5. Repeat step 3 & 4 for the other button head screw on the opposite side and apply loctite.
6. The assembled mount can be fixed to a roll cage bar using the stainless steel clamps supplied.
7. Slide the e-Boost into a loosened clamp and tighten in desired position. Important note: It is recommended that loctite be
used to properly tighten and secure the screws once your e-boost has been fitted and positioned.
Product Name: Roll cage mount kit
Product Description: 60/66mm roll cage mount kit
Product Number: TS-0301-2002, TS-0301-2014
1
3
2
4
6
5
l