Turbosmart BLOW OFF VALVES - Race Port – Universal – New for 2011 - Manual

1
------------------------------------------------------------------------------------------------------------------------
IMPORTANT NOTES ON YOUR RACE PORT

Use only silicone hose that is the correct size and pressure/vacuum rating for your application when fitting your Race Port
 Ensure that all plumbing is secured with suitable clamps or the correct fittings are used
 Your Race Port should be mounted at least 100mm from any high heat source or adequately shielded
 Check the vacuum level produced by your engine to ensure the right spring is installed in your Race Port for maximum response
RECOMMENDATIONS

Turbosmart recommends that your Race Port is fitted and adjusted by an appropriately qualified technician
------------------------------------------------------------------------------------------------------------------------
HOW TO INSTALL YOUR RACE PORT

Allow the engine to cool down before installing your Race Port
 Identify a suitable location along the intercooler/intake piping for the Race Port – this will need to be between the outlet of the turbo
and the throttle body ideally between the throttle body and the intercooler
 Remove the Race port from the weld on adapter by removing the V-Band clamp. The V-band clamp is removed by opening the
screw until it has reached the end stop, then pushing the head of the screw in a “syringe” like motion and lifting the Race Port off
the weld flange.
Step 1: Step 2: Step 3:

Weld the adapter onto the intake pipe in your ideal position, then allow the adapter to cool down
 Put the V-Band clamp over the adapter before re-installing the O-Ring seal and the Race Port
 Open the V-Band clamp and place in position. Tighten the V-Band clamp screw until it is finger tight then turn an additional 2.5
turns or 4 Nm (3 ft/lbs) with an allen key. Be sure not to over tighten the screw as this will cause damage to the V-Band clamp
 Install the provided vacuum nipple into one of the ports in the top cap and install the blanking plug into the other.
 Identify a standalone vacuum / pressure source from a port after the throttle body and connect with correctly sized hose to the
vacuum/boost port nipple on the cap of the Race Port. Ensure this line is as short as possible
 Secure all silicone hose ends with correct clamps
 Start the engine and check for air leaks in the system
RACE PORT DIAGRAM
Product Name: RACE PORT
Product Description: Blow off valve
Product Number: TS-0204-11XX
Bolt head
Squeeze
Lift off
Pull down