Performance sets – Moog Music Little Phatty Stage II User Manual
Page 48
Page 50
LP Stage II User’s Manual - The User Interface
Page 51
LP Stage II User’s Manual - The User Interface
Performance Sets
Performance Sets is a feature that allows you to customize the order of LP presets for a live performance
situation or to enhance your productivity in a studio environment.
Performance Sets are based on the idea that during a performance, you may need to switch between a se-
quence of sounds that doesn’t necessarily match up to the preset locations. Performance Sets gives you the
ability to set up sequences of sounds that you can step through easily and quickly during a performance.
The LP has four Performance Sets located in the Master menu. Each Performance Set contains eight preset
entries, so set 1 has an array of 8 presets; set 2 has an array of 8 presets, etc. Viewed as a table, the
Performance Sets might look like this:
SET
PRESET 1
PRESET 2
PRESET 3
PRESET 4
PRESET 5
PRESET 6
PRESET 7
PRESET 8
1
24
58
02
89
34
38
23
01
2
02
03
51
05
06
92
07
08
3
99
38
56
57
12
13
48
76
4
34
35
36
37
44
45
46
47
The first entry in Set 1 above is Preset 24; the second entry is Preset 58, and so on. Performance Sets allow
you to sequence up to 32 presets for your specific needs. Once the Performance Sets are configured, you
can call up a set and step though the sequence using the VALUE switch.
The example on the right shows the preset stored
in the first location of Performance Set 3 (Preset 99
– SUPERCHUNK). To step through this sequence,
press the VALUE switch. Each press will advance to
the next preset in the sequence. After the eighth pre-
set is reached, the next press of the VALUE switch will
cycle back to the first preset in Performance Set 3.
To return to Preset mode, press the PRESET button.
The preset displayed will be the last preset selected in
the Performance Set.
Pressing the MASTER button again will return to the
last used master menu entry.
Note: The factory default setup for Performance Sets is shown below. When you
perform a Factory Restore operation, all Performance Sets will default to these values:
SET
PRESET 1
PRESET 2
PRESET 3
PRESET 4
PRESET 5
PRESET 6
PRESET 7
PRESET 8
1
00
01
02
03
04
05
06
07
2
08
09
10
11
12
13
14
15
3
16
17
18
19
20
21
22
23
4
24
25
26
27
28
29
30
31