Moog Music MF-104Z Analog Delay - Manual (Page 4)

4
Turn the volume control on your amp down but not off.
5. Connect an instrument cable from your signal source to the AUDIO
IN
jack. You can feed virtually any instrument-level or line-level
signal through your MF-104Z. Examples are guitar, bass, keyboard,
theremin, drum machine, or Effects Send output on your mixer.
Refer to Figure 2 for step 6.
6. Set the MF-104Z panel controls as follows.
MIX
0
DELAY TIME 0.3
FEEDBACK 0
LOOP GAIN 0
DRIVE fully
counterclockwise
OUTPUT LEVEL fully
counterclockwise
Left Switch SHORT
Right Switch INT. LOOP
Play your instrument (or turn on
the signal source). Adjust the
volume control on your monitor
amp so that the sound level is
comfortable.
Now set the DRIVE and OUTPUT
LEVEL
controls exactly as
described in steps 7. and 8.
7. Press the stomp switch so the
BYPASS
light goes green. Playing your instrument, set the DRIVE
control so the INPUT LEVEL indicator lights up green-yellow or red-
yellow most of the time, and becomes bright red only on occasional
peaks.
8. Set the OUTPUT LEVEL control so that there is no loudness change
when the BYPASS light goes back and forth between green and red.
Once the DRIVE and OUTPUT LEVEL controls are set, you should not
change them unless you change the loudness of your signal source.
Figure 2 - Basic settings for becoming
familiar with your MF-104Z.