Cobalt Digital COMPASS 9033 Input Processing Analog to Digital Video - Manual (Page 63)

9033-OM (V4.0) 9033 PRODUCT MANUAL 3-25
Operating Instructions
9033 Function Submenu List and Descriptions
AES Audio Out Pairs 5-8
Routes audio sources to AES output channels 9 thru 16
(AES Audio Out Pairs 5-8). Also provides Gain, Muting,
and Phase Invert controls for each channel.
Note: • AES Ch 9 thru AES Ch 16 have controls that are identical to the Source, Gain, Mute, and Phase controls described
for AES Ch 1. Refer to AES Audio Out Pairs 1-4 on page 3-21 for descriptions of these controls.
• For each channel, its source and destination should be considered and appropriately set. Unused destination channels
should be set to the Silence selection.
Dolby Metadata
(9033 only) Extracts and preserves Dolby
®
metadata
from the input video, and in turn allows the metadata to
be re-inserted in the output SDI.
• Metadata Embedding Metadata Embedding (On/Off) controls SMPTE 2020-1 metadata
embedding in the SDI video output.
• When set to On, metadata is extracted from the input video, buffered,
and re-directed to the output SDI video.
• When set to Off, metadata is not embedded in the output SDI video.
• Metadata Output Line Allows selection of SMPTE 2020-1 metadata line location within the VANC
space for re-inserted Dolby
®
metadata.
(Range is 9 thru 41; default is line #13.)
Note: • Although the output line drop-down will allow any choice within the
9 thru 41 range, the actual range is automatically clamped (limited
to) certain ranges to prevent inadvertent conflict with active
picture area depending on video format. See Ancillary Data Line
Number Locations and Ranges (p. 3-8) for more information.
• The card does not check for conflicts on a given line number.
Make certain the selected line is available and carrying no other
data unless existing metadata is to be intentionally overwritten.
Note: (9033 only) The Metadata Output Source button in DashBoard™ is locked to Input Video for this card. With this
function enabled, the extracted metadata is always available in the SDI video output and on cards equipped with an
appropriate Rear I/O Module having a Dolby
® metadata RS-485 connector.
Table 3-2 9033 Function Submenu List — continued