Cobalt Digital FUSION 3G 9985 3G_HD_SD Loudness Processor - Manual (Page 31)

9985-OM (V1.18) 9985 PRODUCT MANUAL 1-27
Introduction
Technical Specifications
Table 1-4 Technical Specifications
Item Characteristic
Part number, nomenclature 9985 HD/SD Loudness Processor with Frame Sync
Installation/usage environment Intended for installation and usage in frame meeting openGear ®
modular system definition.
Power consumption 28 Watts (nominal)
The following options add power consumption as follows:
• +KEYER option: 2 Watts
• +DEC (Dolby
® decoder) option: 2 Watts
• +ANA, +ANV (analog audio/video I/O) options: 15 Watts (typical)
Environmental:
Operating temperature:
Relative humidity (operating or storage): 32° – 104° F (0° – 40° C)
< 95%, non-condensing
Frame communication 10/100 Mbps Ethernet with Auto-MDIX.
Internal Tone Generators Eight built-in tone generators, each configurable for 18 discrete sine
wave frequencies ranging from 50 Hz to 16 kHz.
Generator source signal level is equivalent to -20 dBu.
Note: SMPTE 425 specifications below only with option +3G
Standards Supported (SDI) 3G: SMPTE 425 level A
1080p60, 1080p59.94, 1080p50
HD: 1080i60, 1080i59.94, 1080i50, 1080p29.97, 1080p25, 1080p24;
1080p23.98
720p60, 720p59.94, 720p50, 720p29.97, 720p25, 720p24,
720p23.98
SD: 486i59094, 576i50
BNC SDI Video Inputs/Outputs Input/Output Complement:
• Four BNC input connectors (maximum)
• Four BNC output connectors (maximum)
Data Rates Supported:
SMPTE 425 level A and B: 3 Gbps
SMPTE 292 HD-SDI: 1.485 Gbps or 1.485/1.001 Gbps
SMPTE 259M-C SD-SDI: 270 Mbps
BNC Connector Input/Output Impedance:
75 Ω terminating
Cable Equalization (3G):
394 ft (120 m) Belden 1694A
Cable Equalization (HD):
591 ft (180 m) Belden 1694A
Cable Equalization (SD):
1050 ft (320 m) Belden 1694A
Return Loss:
> 15 dB up to 1.485 GHz
> 10 dB up to 2.970 GHz
Jitter; Alignment (3G / HD / SD):
< 0.3 UI / 0.2 UI / 0.2 UI
Jitter; Timing (3G / HD / SD):
< 2.0 UI / 1.0 UI / 0.2 UI