Cobalt Digital COMPASS 9021 Standard Definition A_D Analog Composite, Y_C, Component to 10-bit SDI - Manual (Page 11)

9021 Owner’s Manual •••• (V 1.1) Page 11 of 22
Rear Module Installation (Optional)
If you are installing the card in a 8310-C-BNC or 8310-BNC frame (one with a 100 BNC rear module
installed across the entire back plane), skip this section.
If you are installing the card into a slot with no rear module, you should have ordered and received an
appropriate 9021rear module. You will need to install it in your frame before you can connect cables.
Use the following steps to install a rear module in a frame:
1. On the rear of the frame, locate the card frame slot.
2. As shown in Figure 2, seat the bottom of the rear module in the seating slot at the
base of the frame’s back plane.
Figure 2. Rear Module Installation
3. Align the top hole of the rear module with the screw hole on the top edge of the
frame back plane.
4. Using a Phillips driver and the supplied screw, fasten the rear module to the frame
back plane. Do not over tighten.
All modules are installed using the same method above.
The following section contains a drawing of the RM-9021-A module.