Cobalt Digital COMPASS 9341 8-channel Analog Audio to AES Converter - Manual (Page 26)

2
Installing a Rear I/O Module
2-4 9341 PRODUCT MANUAL 9341-OM (V4.1)
Installing a Rear I/O Module
Note: This procedure is applicable only if a Rear I/O Module is not currently
installed in the slot where the 9341 is to be installed.
If installing the 9341 in a slot already equipped with a suitable I/O module,
omit this procedure.
Install a Rear I/O Module as follows:
1. On the frame, determine the slot in which the 9341 is to be installed.
2. In the mounting area corresponding to the slot location, install
Rear I/O Module as shown in Figure 2-1.
Figure 2-1 Rear I/O Module Installation
DSCN3483A.JPG
Align and engage mounting tab on Rear
I/O Module with the module seating slot
on rear of frame chassis.
Hold top of Rear I/O Module flush against
frame chassis and start the captive screw.
Lightly tighten captive screw.
DSCN3487A.JPG
1
2
Note: Rear I/O Module RM20-9341-D occupies two rear module
slot mounting locations and use two captive screws.