Rotary axis – OMAX Rotary Axis User Manual
Page 2
ROTARY AXIS
When used with the A-Jet, oblique angle and bevel-edged
holes can be cut along the circumference of pipes.
Programming for Rotary Axis cutting is simple, with advanced
tools built into the Intelli-MAX Software Suite.
ADVANCED 3D CAPABILITY
The continuous motion of the Rotary Axis coupled with advanced software
features in the latest Intelli-MAX Software Suite and the A-Jet articulated cutting
head opens up new capabilities of your OMAX JetMachining Center. Complex
beveled openings can be generated parametrically for simple creation of
challenging weld prep pipe fittings.
CAPABILITIES
•
10,000 steps per revolution standard
•
11 ft-lb (15N*m) constant torque; 28 ft-lb (39N*m) maximum torque
•
Maximum radial load at end of output shaft 391 lbf (1.74kN)
•
Maximum radial load 12” from end of the output shaft 67 lbf (0.289kN)
•
Maximum radial load 24” from end of the output shaft 36 lbf (0.164kN)
•
On larger format machines, maximum diameter 24” (cannot exceed load or
torque limit)
•
0.01 degree of repeatability: at 1” diameter = 0.0001”; at
10” diameter = 0.0008”
•
XYZ and A axes with standard motorized Z; XYZ, A, TX, and TY with Tilt-A-Jet
or A-Jet cutting head
REQUIREMENTS
•
9-axis controller back panel design for installation
•
OMAX Intelli-MAX® 18 Software Suite or later
RECOMMENDED ACCESSORIES
•
Universal Adapter Flange Blank
•
ER40 Collet Adapter with ½”, ¾”, and 1” collet sizes
•
Extension Cable Assembly to locate Rotary Control Box further away
The Rotary Axis can cut small diameter tube and pipe with
high precision.
OMAX CORPORATION
21409 72nd Avenue South
Kent, WA 98032
TEL
1-253-872-2300
/
1-800-838-0343
FAX
1-253-872-6190
WWW.OMAX.COM
Made in the USA
Specifications subject to change without notice.
600079B January 2014