Placing a smartphone in the holder, Attaching to air vent louvers – RocketFish RF-VMU5 - User Manual User Manual

Page 4

Advertising
background image

4

3 Position the kickstand so it rests against

other louvers or the dash for support.

4 Loosen the swivel head knob, adjust

the viewing angle, then fully tighten
the knob.


Caution: Do not adjust your Rocketfi sh
car mount while driving.

Placing a smartphone in the
holder

1 Repeatedly press the release button on

the side of the holder. The clamps open.

2 Unfold the feet on the bottom of the

holder.

3 Adjust the clamps to fi t the width of

your smartphone.

4 Place your smartphone in the holder

and close the clamps by squeezing
them together tightly until your phone
is secure.

Attaching to air vent louvers

1 Insert the swivel head into the slot on

the back of the holder and slide it into
place until it is secure.


2 Align the clip stops with the edge of an

air vent louver, slowly push the mount
back until it clicks into place, then
release the mount. Make sure both
hooks are attached to the louver.

Advertising