TC Electronic Finalizer Express - Manual (Page 25)

23
APPENDIX Troubleshooting
You press the POWER switch, but there is no reaction.
• The power switch on the rear panel is switched off.
You cannot turn the power off.
• Press and hold the POWER switch for 3 seconds, then release to power off.
No sound through the Finalizer Express.
• You are using analog Input, but the INPUT selector is set to digital. Press the “SELECT INPUT” key until the “analog” LED is lit.
The incoming Sample Rate is 44.1kHz, but the Finalizer Express sends out 48kHz.
• You are using digital Input but the Finalizer Express is set to use its own internal clock. Press the “Sync from” key to select the
digital clock.
Your DAT recorder will not accept the digital signal from the Finalizer Express
• Try to change the digital Status bits Output from the Finalizer Express by pressing the “digital Out” key.
The digital fader of the Finalizer Express is not working
• Make sure that both External Control LEDs are turned off in the Fade In/Out section.
The digital fader is not responding to MIDI
• Make sure that you selected the correct MIDI channel by pressing the FINALIZE SOFTCLIP key and the “ARROW-UP” key
simultaneously.