Rainbow Electronics MAX19993 User Manual

Page 6

Advertising
background image

MAX19993

Dual, SiGe, High-Linearity, 1200MHz to 1700MHz

Downconversion Mixer with LO Buffer/Switch

6

Note_5: 100% production tested for functionality.
Note_6: Not production tested. Operation outside this range is possible, but with degraded performance of some parameters. See

the Typical Operating Characteristics section.

Note_7: All limits reflect losses of external components, including a 0.5dB loss at f

IF

= 140MHz due to the 4:1 transformer. Output

measurements were taken at IF outputs of the Typical Application Circuit.

Note_8: Maximum reliable continuous input power applied to the RF or IF port of this device is +12dBm from a 50I source.
Note_9: Not production tested.
Note_10: Measured with external LO source noise filtered so the noise floor is -174dBm/Hz. This specification reflects the effects

of all SNR degradations in the mixer, including the LO noise as defined in Application Note 2021: Specifications and
Measurement of Local Oscillator Noise in Integrated Circuit Base Station Mixers
.

3.3V_SUPPLY,_LOW_SIDE_INJECTION_AC_ELECTRICAL_CHARACTERISTICS_(continued)

(Typical Application Circuit (see Table 1). R1 = R4 = 681I, R2 = R5 = 1.43kI. Typical values are at V

CC

= 3.3V, P

RF

= -5dBm, P

LO

= 0dBm,

f

RF

= 1450MHz, f

LO

= 1310MHz, f

IF

= 140MHz, T

C

= +25NC, unless otherwise noted.) (Note 7)

PARAMETER

SYMBOL

CONDITIONS

MIN

TYP

MAX

UNITS

IF Output Return Loss

RF terminated into 50I, LO driven by
50I source, IF transformed to 50I using
external components shown in the Typical
Application Circuit

15

dB

RF-to-IF Isolation

33

dB

LO Leakage at RF Port

-45

dBm

2LO Leakage at RF Port

-27

dBm

LO Leakage at IF Port

-22

dBm

Channel Isolation

RFMAIN converted power measured at
IFDIV relative to IFMAIN, all unused ports
terminated to 50I

47

dB

RFDIV converted power measured at
IFMAIN relative to IFDIV, all unused ports
terminated to 50I

47

LO-to-LO Isolation

P

LO1

= +3dBm, P

LO2

= +3dBm,

f

LO1

= 1310MHz, f

LO2

= 1311MHz

57

dB

LO Switching Time

50% of LOSEL to IF settled within
2 degrees

50

ns

Advertising