Electrical characteristics (continued) – Rainbow Electronics MAXQ7670 User Manual
Page 8
MAXQ7670
Microcontroller with 10-Bit ADC,
PGA, 64KB Flash, and CAN Interface
8
_______________________________________________________________________________________
Note 1:
All devices are 100% production tested at T
A
= +25°C and +125°C. Temperature limits to T
A
= -40°C are guaranteed by
design.
Note 2:
All analog functions disabled and all digital inputs connected to supply or ground.
Note 3:
High-speed/8 mode without CAN; V
DVDD
= +2.5V, CPU and 16-bit timer running at 2MHz from an external, 16MHz crystal
oscillator; all other peripherals disabled; all digital I/Os static at V
DVDDIO
or GNDIO; T
A
= T
MIN
to T
MAX
.
Note 4:
High-speed/1 mode with CAN; V
DVDD
= +2.5V, CPU and 16-bit timer running at 16MHz from an external, 16MHz crystal
oscillator; CAN enabled and communicating at 500kbps; all other peripherals disabled, all digital I/Os (except CANTXD
and CANRXD) static at V
DVDDIO
or GNDIO, T
A
= T
MIN
to T
MAX
.
Note 5:
Low speed, PMM1 mode without CAN; V
DVDD
= +2.5V, CPU and one timer running from an external, 16MHz crystal oscilla-
tor in PMM1 mode; all other peripherals disabled; all digital I/Os static at V
DVDDIO
or GNDIO, T
A
= T
MIN
to T
MAX
.
Note 6:
CAN transmitting at 500kbps; 16-bit timer output switching at 500kHz; all active I/Os are loaded with a 20pF capacitor; all
remaining digital I/Os are static at V
DVDDIO
or GNDIO, T
A
= T
MIN
to T
MAX
.
Note 7:
Guaranteed by design and characterization.
Note 8:
This is not a static capacitance. It is the capacitance presented to the analog input when the T/H amplifier is in sample mode.
Note 9:
The switched capacitor on the REFADC input can disturb the reference voltage. To reduce this disturbance, place a 0.1µF
capacitor from REFADC to AGND as close as possible to REFADC.
Note 10: The digital design is fully static. However, the lower clock limit is set by a clock detect circuit. The MAXQ7670 switches to
the internal RC clock if the external input goes below 166kHz. This clock detect circuit also acts to detect a crystal failure
when a crystal is used.
ELECTRICAL CHARACTERISTICS (continued)
(V
DVDDIO
= +5.0V, V
AVDD
= +3.3V, V
DVDD
= +2.5V, V
REFADC
= +3.3V, system clock = 16MHz. T
A
= T
MIN
to T
MAX
, unless otherwise
noted. Typical values are at T
A
= +25°C.) (Note 1)
PARAMETER
SYMBOL
CONDITIONS
MIN
TYP
MAX
UNITS
SS Falling Edge to First SCLK
Sample Edge
t
SSE
2 t
SYSCLK
+ 5
ns
SCLK Inactive to SS Rising
Edge
t
SD
t
SYSCLK
+ 10
ns
Minimum CS Pulse Width
t
SCW
t
SYSCLK
+ 10
ns