Rainbow Electronics QIL-A9260-C11 - Manual (Page 7)

S
ECTION
3
1. Board Description
AT91SAM9260 Microcontroller:

Incorporates the ARM926EJ-S™ ARM® Thumb® Processor
✔
DSP Instruction Extensions, ARM Jazelle® Technology for Java®Acceleration
✔
8-KByte Data Cache, 8-KByte Instruction Cache, Write Buffer
✔
200 MIPS at 180 Mhz
✔
Memory Management Unit
✔
EmbeddedICE™, Debug Communication Channel Support

Additional Embedded Memories
✔
One 32-KByte Internal ROM, Single-cycle Access At Maximum Matrix Speed
✔
Two 4-KByte Internal SRAM, Single-cycle Access At Maximum Matrix Speed

External Bus Interface (EBI)
✔
Supports SDRAM, Static Memory, ECC-enabled NANDFlash and CompactFlash®

USB 2.0 Full Speed (12 Mbits per second) Device Port
✔
On-chip Transceiver, 2,432-byte Configurable Integrated DPRAM

USB 2.0 Full Speed (12 Mbits per second) Host Single Port in the 208-lead PQFP Package
and Double Port in 217-ball LFBGA Package
✔
Single or Dual On-chip Transceivers
✔
Integrated FIFOs and Dedicated DMA Channels

Ethernet MAC 10/100 Base T
✔
Media Independant Interface or Reduced Media Independant Interface
✔
28-byte FIFOs and Dedicated DMA Channels for Receive and Transmit

Image Sensor Interface
✔
ITU-R BT. 601/656 External Interface, Programmable Frame Capture Rate
✔
12-bit Data Interface for Support of High Sensibility Sensors
✔
SAV and EAV Synchronization, Preview Path with Scaler, YCbCr Format
■
Bus Matrix
✔
Six 32-bit-layer Matrix
✔
Boot Mode Select Option, Remap Command

Fully-featured System Controller, including
✔
Reset Controller, Shutdown Controller
✔
Four 32-bit Battery Backup Registers for a Total of 16 Bytes
✔
Clock Generator and Power Management Controller
✔
Advanced Interrupt Controller and Debug Unit
✔
Periodic Interval Timer, Watchdog Timer and Real-time Timer
Datasheet USG-00006-A01 7/20