Rainbow Electronics MAX5184 - Manual (Page 2)

MAX5181/MAX5184
10-Bit, 40MHz, Current/Voltage-Output DACs
2 _______________________________________________________________________________________
ABSOLUTE MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS
(AV DD = DV DD = +3V ±10%, AGND = DGND = 0, f CLK = 40MHz, I FS = 1mA, 400 Ω differential output, C
L = 5pF, T A = T MIN to T MAX ,
unless otherwise noted. Typical values are at T A = +25°C.)
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
AV DD , DV DD to AGND, DGND .................................-0.3V to +6V
Digital Inputs to DGND.............................................-0.3V to +6V
OUTP, OUTN, CREF to AGND .................................-0.3V to +6V
V
REF to AGND ..........................................................-0.3V to +6V
AGND to DGND.....................................................-0.3V to +0.3V
AV
DD to DV DD .................................................................... ±3.3V
Maximum Current into Any Pin............................................50mA
Continuous Power Dissipation (T A = +70°C)
24-Pin QSOP (derate 9.50mW/°C above +70°C) ........762mW
Operating Temperature Range
MAX518_BEEG ................................................-40°C to +85°C
Storage Temperature Range .............................-65°C to +150°C
Lead Temperature (soldering, 10s) .................................+300°C
MAX5181 only
MAX5181 only
DACEN = 0, MAX5181 only
All 0s to all 1s
To ±0.5LSB error band
Guaranteed monotonic
MAX5181
(Note 1)
CONDITIONS
Ω 400 R L
DAC External Output Resistor
Load
mA 0.5 1 1.5 I FS Full-Scale Output Current
µA -1 1 Output Leakage Current
V -0.3 0.8 Voltage Compliance of Output
mV 400 V FS Full-Scale Output Voltage
pA/ √Hz 10 Output Noise
LSB -2 ±0.5 +2 INL Integral Nonlinearity
Bits 10 N Resolution
nVs 50 Clock and Data Feedthrough
dBc
72
SFDR
Spurious-Free Dynamic Range
to Nyquist
pVs 10 Glitch Impulse
ns 25 Output Settling Time
LSB -1 ±0.5 1 DNL Differential Nonlinearity
-2 +2
Zero-Scale Error
LSB -40 ±15 +40 Full-Scale Error
UNITS MIN TYP MAX SYMBOL PARAMETER
57 70
-68 -63
dB
-70
THD
Total Harmonic Distortion
to Nyquist
56 59
dB
61
SNR Signal-to-Noise Ratio to Nyquist
f OUT = 550kHz
f OUT = 2.2MHz, T A = +25°C
f OUT = 550kHz
f OUT = 2.2MHz, T A = +25°C
f OUT = 550kHz
f OUT = 2.2MHz, T A = +25°C
f CLK = 40MHz
f CLK = 40MHz
f CLK = 40MHz
DYNAMIC PERFORMANCE
STATIC PERFORMANCE
ANALOG OUTPUT
MAX5184 -8 +8
LSB