Rainbow Electronics CLC001 - Manual (Page 8)

Device Operation
(Continued)
A typical LVDS input connection is shown in Figure 9. The
media is driven differentially by an LVDS driver. The line is
terminated with a termination resistor equal to the
impedance of the line being driven. The actual resistor
value is media specific, but typically is between 100 and
120
Ω
. This resistor should be located close to the
CLC001 inputs pins to minimize the resulting stub length
between the resistor and device pads. The CLC001
supports
± 100mV thresholds across the entire LVDS
common mode range of 0.1V to 2.3V for a 200mV
differential signal.
DS101329-9
FIGURE 9. LVDS, DC-coupled
CLC001
www.national.com 8