Rainbow Electronics AT29C512 - Manual (Page 3)

3
AT29C512
0456E–FLASH–5/02
SOFTWARE DATA PROTECTION: A software controlled data protection feature is avail-
able on the AT29C512. Once the software protection is enabled a software algorithm must be
issued to the device before a program may be performed. The software protection feature may
be enabled or disabled by the user; when shipped from Atmel, the software data protection
feature is disabled. To enable the software data protection, a series of three program com-
mands to specific addresses with specific data must be performed. After the software data
protection is enabled the same three program commands must begin each program cycle in
order for the programs to occur. All software program commands must obey the sector pro-
gram timing specifications. Once set, the software data protection feature remains active
unless its disable command is issued. Power transitions will not reset the software data pro-
tection feature; however, the software feature will guard against inadvertent program cycles
during power transitions.
Once set, software data protection will remain active unless the disable command sequence is
issued.
After setting SDP, any attempt to write to the device without the 3-byte command sequence
will start the internal write timers. No data will be written to the device; however, for the dura-
tion of t
WC
, a read operation will effectively be a polling operation.
After the software data protection’s 3-byte command code is given, a byte load is performed
by applying a low pulse on the WE or CE input with CE or WE low (respectively) and OE high.
The address is latched on the falling edge of CE or WE, whichever occurs last. The data is
latched by the first rising edge of CE or WE. The 128 bytes of data must be loaded into each
sector by the same procedure as outlined in the program section under device operation.
HARDWARE DATA PROTECTION: Hardware features protect against inadvertent pro-
grams to the AT29C512 in the following ways: (a) V
CC
sense – if V
CC
is below 3.8V (typical),
the program function is inhibited; (b) V
CC
power on delay – once V
CC
has reached the V
CC
sense level, the device will automatically time out 5 ms (typical) before programming; (c) Pro-
gram inhibit – holding any one of OE low, CE high or WE high inhibits program cycles; and (d)
Noise filter – pulses of less than 15 ns (typical) on the WE or CE inputs will not initiate a pro-
gram cycle.
PRODUCT IDENTIFICATION: The product identification mode identifies the device and
manufacturer as Atmel. It may be accessed by hardware or software operation. The hardware
operation mode can be used by an external programmer to identify the correct programming
algorithm for the Atmel product. In addition, users may wish to use the software product identi-
fication mode to identify the part (i.e., using the device code), and have the system software
use the appropriate sector size for program operations. In this manner, the user can have a
common board design for 256K to 4-megabit densities and, with each density’s sector size in
a memory map, have the system software apply the appropriate sector size.
For details, see Operating Modes (for hardware operation) or Software Product Identification.
The manufacturer and device code is the same for both modes.