Rainbow Electronics ATmega3290P_V - Manual (Page 232)

232
ATmega329/3290/649/6490
2552H–AVR–11/06
LCDFRR – LCD Frame Rate
Register
• Bit 7 – Res: Reserved Bit
This bit is reserved bit in the ATmega329/3290/649/6490 and will always read as zero.
• Bits 6:4 – LCDPS2:0: LCD Prescaler Select
The LCDPS2:0 bits selects tap point from a prescaler. The prescaled output can be fur-
ther divided by setting the clock divide bits (LCDCD2:0). The different selections are
shown in Table 102. Together they determine the prescaled LCD clock (clk
LCD_PS
),
which is clocking the LCD module.
• Bit 3 – Res: Reserved Bit
This bit is reserved bit in the ATmega329/3290/649/6490 and will always read as zero.
• Bits 2:0 – LCDCD2:0: LCD Clock Divide 2, 1, and 0
The LCDCD2:0 bits determine division ratio in the clock divider. The various selections
are shown in Table 103. This Clock Divider gives extra flexibility in frame rate selection.
Bit 7 6 5 4 3 2 1 0
(0xE6) – LCDPS2 LCDPS1 LCDPS0 – LCDCD2 LCDCD1 LCDCD0 LCDFRR
Read/Write R R/W R/W R/W R R/W R/W R/W
Initial Value 0 0 0 0 0 0 0 0
Table 102. LCD Prescaler Select
LCDPS2 LCDPS1 LCDPS0
Output from
Prescaler
clk
LCD
/N
Applied Prescaled LCD Clock
Frequency when LCDCD2:0 = 0,
Duty = 1/4, and Frame Rate = 64 Hz
0 0 0 clk
LCD
/16 8.1 kHz
0 0 1 clk
LCD
/64 33 kHz
0 1 0 clk
LCD
/128 66 kHz
0 1 1 clk
LCD
/256 130 kHz
1 0 0 clk
LCD
/512 260 kHz
1 0 1 clk
LCD
/1024 520 kHz
1 1 0 clk
LCD
/2048 1 MHz
1 1 1 clk
LCD
/4096 2 MHz