Power-up reset, Preload of registered outputs, Electronic signature word – Rainbow Electronics ATF22V10CQ User Manual

Page 6: Security fuse usage, Programming/ erasing, Atf22v10c(q)

Advertising
background image

6

ATF22V10C(Q)

0735P–PLD–01/02

Power-up Reset

The registers in the ATF22V10Cs are designed to reset during power-up. At a point
delayed slightly from V

CC

crossing V

RST

, all registers will be reset to the low state. The

output state will depend on the polarity of the output buffer.

This feature is critical for state machine initialization. However, due to the asynchronous
nature of reset and the uncertainty of how V

CC

actually rises in the system, the following

conditions are required:

1.

The V

CC

rise must be monotonic, and starts below 0.7V,

2.

After reset occurs, all input and feedback setup times must be met before driving
the clock pin high, and

3.

The clock must remain stable during t

PR

.

Preload of Registered
Outputs

The ATF22V10C’s registers are provided with circuitry to allow loading of each register
with either a high or a low. This feature will simplify testing since any state can be forced
into the registers to control test sequencing. A JEDEC file with preload is generated
when a source file with vectors is compiled. Once downloaded, the JEDEC file preload
sequence will be done automatically by most of the approved programmers after the
programming.

Electronic Signature
Word

There are 64 bits of programmable memory that are always available to the user, even if
the device is secured. These bits can be used for user-specific data.

Security Fuse Usage

A single fuse is provided to prevent unauthorized copying of the ATF22V10C fuse pat-
terns. Once programmed, fuse verify and preload are inhibited. However, the 64-bit
User Signature remains accessible.

The security fuse should be programmed last, as its effect is immediate.

Programming/
Erasing

Programming/erasing is performed using standard PLD programmers. See “CMOS PLD
Programming Hardware & Software Support” for information on software/programming.

C

LOCK

V

R

ST

POWER

REGISTERED
OUTPUTS

t

S

t

PR

t

W

Parameter

Description

Typ

Max

Units

t

PR

Power-up Reset Time

600

1,000

ns

V

RST

Power-up Reset Voltage

3.8

4.5

V

Advertising