Rainbow Electronics MAX3301E - Manual

General Description
The MAX3301E fully integrated USB On-the-Go (OTG)
transceiver and charge pump allows mobile devices
such as PDAs, cellular phones, and digital cameras to
interface directly with USB peripherals and each other
without the need of a host PC. Use the MAX3301E with
an embedded USB host to directly connect to peripher-
als such as printers or external hard drives.
The MAX3301E integrates a USB OTG transceiver, a
V
BUS charge pump, a linear regulator, and an I 2 C™-
compatible, 2-wire serial interface. An internal level
shifter allows the MAX3301E to interface with logic sup-
ply voltages from +1.65V to +3.6V. The MAX3301E’s
OTG-compliant charge pump operates with +3V to
+4.5V input supply voltages, and supplies an OTG-com-
patible output on V
BUS while sourcing more than 8mA of
output current.
The MAX3301E enables USB OTG communication from
highly integrated digital devices that cannot supply or tol-
erate the +5V V
BUS levels that USB OTG requires. The
device supports USB OTG session-request protocol
(SRP) and host-negotiation protocol (HNP) by controlling
and measuring V
BUS using internal comparators.
The MAX3301E provides built-in ±15kV electrostatic-
discharge (ESD) protection for the V
BUS , ID_IN, D+,
and D- terminals. The MAX3301E is available in 5 x 5
chip-scale (UCSP™) and 32-pin (5mm x 5mm x 0.8mm)
thin QFN packages and operates over the extended
-40
°C to +85°C temperature range.
Applications
Mobile Phones
PDAs
Digital Cameras
MP3 Players
Photo Printers
Features
♦ USB 2.0-Compliant Full-/Low-Speed OTG
Transceivers
♦ Ideal for USB On-the-Go, Embedded Host, or
Peripheral Devices
♦ ±15kV ESD Protection on ID_IN, V
BUS , D+, and D-
Terminals
♦ Charge Pumps for V
BUS Signaling and Operation
Down to 3V
♦ Internal V
BUS and ID Comparators
♦ Internal Switchable Pullup and Pulldown
Resistors for Host/Peripheral Functionality
♦ I 2 C Bus Interface with Command and Status
Registers
♦ Linear Regulator Powers Internal Circuitry and
D+/D- Pullup Resistors
♦ Supports Car Kit Interrupts and Audio-Mode
Operation
♦ Supports SRP and HNP
♦ Low-Power Shutdown Mode
♦ Available in 32-Pin Thin QFN and 5 x 5 UCSP
Packages
MAX3301E
USB On-the-Go Transceiver and Charge Pump
________________________________________________________________ Maxim Integrated Products 1
Ordering Information
19-3275; Rev 1; 10/04
For pricing, delivery, and ordering information, please contact Maxim/Dallas Direct! at
1-888-629-4642, or visit Maxim’s website at www.maxim-ic.com.
PART
TEMP
RANGE
PIN-
PACKAGE PKG.
CODE
MAX3301EETJ -40°C to +85°C
32 Thin
QFN-EP*
T3255-4
MAX3301EEBA-T -40°C to +85°C 5 x 5 UCSP B25-1
Purchase of I 2 C components from Maxim Integrated Products,
Inc. or one of its sublicensed Associated Companies, conveys a
license under the Philips I
2 C Patent Rights to use these compo-
nents in an I 2 C system, provided that the system conforms to the
I 2 C Standard Specification as defined by Philips.
UCSP is a trademark of Maxim Integrated Products, Inc.
Typical Operating Circuit and Pin Configurations appear at
end of data sheet.
*EP = Exposed paddle.
**Requires solder temperature profile described in the Absolute
Maximum Ratings section. UCSP reliability is integrally linked to
the user’s assembly methods, circuit board material, and environ-
ment. See the UCSP Reliability Notice in the UCSP Applications
Information section of this data sheet for more information.