Rainbow Electronics MAX3033E - Manual (Page 2)

MAX3030E–MAX3033E
±15kV ESD-Protected, 3.3V Quad
RS-422 Transmitters
2 _______________________________________________________________________________________
ABSOLUTE MAXIMUM RATINGS
DC ELECTRICAL CHARACTERISTICS
(3V ≤ V
CC
≤ 3.6V, T
A
= T
MIN
to T
MAX
, unless otherwise noted. Typical values are at V
CC
= +3.3V and T
A
= +25°C.) (Note 1)
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
(All Voltages Are Referenced to Device Ground, Unless
Otherwise Noted)
V
CC ........................................................................................+6V
EN1&2, EN3&4, EN, EN............................................-0.3V to +6V
DI_ ............................................................................-0.3V to +6V
DO_+, DO_- (normal condition) .................-0.3V to (V
CC + 0.3V)
DO_+, DO_- (power-off or three-state condition).....-0.3V to +6V
Driver Output Current per Pin.........................................±150mA
Continuous Power Dissipation (T A = +70°C)
16-Pin SO (derate 8.70mW/°C above +70°C)..............696mW
16-Pin TSSOP (derate 9.40mW/°C above +70°C) .......755mW
Operating Temperature Ranges
MAX303_EC_ ......................................................0°C to +70°C
MAX303_EE_ ...................................................-40°C to +85°C
Junction Temperature ......................................................+150°C
Storage Temperature Range .............................-65°C to +160°C
Lead Temperature (soldering, 10s) .................................+300°C
PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS
DRIVER OUTPUT: DO_+, DO_-
V OD1 R L = 100 Ω, Figure 1 2.0
V OD2 R L = ∞, Figure 1 3.6
Differential Driver Output
V OD3
R L = 3.9k Ω (for compliance with V.11),
Figure 1
3.6
V
Change in Differential Output
Voltage
∆V
OD R L = 100 Ω (Note 2) -0.4 +0.4 V
Driver Common-Mode Output
Voltage
V OC R L = 100 Ω, Figure 1 3 V
Change in Common-Mode
Voltage
∆V
OC R L = 100 Ω (Note 2) -0.4 +0.4 V
Three-State Leakage Current I OZ V OUT = V CC or GND, driver disabled ±10 µA
Output Leakage Current I OFF V CC = 0V, V OUT = 3V or 6V 20 µA
Driver Output Short-Circuit
Current
I SC
V OUT = 0V, V IN = V CC or GND
(Note 3)
-150 mA
INPUTS: EN,
EN, EN1&2, EN3&4
Input High Voltage V IH 2.0 V
Input Low Voltage V IL 0.4 V
Input Current I
LEAK
±2 µA
Hot-Swap Driver Input Current I HOTSWAP EN, EN, EN1&2, EN3&4 (Note 4) ±200 µA
SUPPLY CURRENT
Supply Current I CC No load 100 µA
THERMAL PROTECTION
Thermal-Shutdown Threshold T SH 160 °C
Thermal-Shutdown Hysteresis 10 °C
ESD Protection DO_ Human Body Model ±15 kV