Rainbow Electronics MAX1011 - Manual (Page 3)

MAX1011
Low-Power, 90Msps, 6-Bit ADC
_______________________________________________________________________________________ 3
AC ELECTRICAL CHARACTERISTICS
(V CC = +5V ±5%, V CCO = 3.3V ±300mV, T A = +25°C , unless otherwise noted.)
Note 1: Best-fit straight-line linearity method.
Note 2: A typical application will AC couple the analog input to the DC bias level present at the analog inputs (typically 2.35V).
However, it is also possible to DC couple the analog input (using differential or single-ended drive) within this common-
mode input range (Figures 4 and 5).
Note 3: PSRR is defined as the change in the mid-gain, full-scale range as a function of the variation in V CC supply voltage,
expressed in decibels.
Note 4: The current in the V CCO supply is a strong function of the capacitive loading on the digital outputs. To minimize supply tran-
sients and achieve optimal dynamic performance, reduce the capacitive-loading effects by keeping line lengths on the dig-
ital outputs to a minimum.
Note 5: Offset-correction compensation enabled, 0.22µF at compensation inputs (Figures 2 and 3).
Note 6: t PD and t SKEW are measured from the 1.4V level of the output clock, to the 1.4V level of either the rising or falling edge of a
data bit. t DCLK is measured from the 50% level of the clock-overdrive signal on TNK+ to the 1.4V level of DCLK. The capac-
itive load on the outputs is 15pF.
GAIN = GND, open, V CC
GAIN = open (mid gain), f IN = 50MHz,
-1dB below full scale
GAIN = open (mid gain)
5.7
ENOB M
5.6 5.85
Effective Number of Bits
GAIN = open (mid gain)
GAIN = GND (low gain)
Guaranteed by design
CONDITIONS
MHz 55 BW Analog Input -0.5dB Bandwidth
Msps 90 f MAX Maximum Sample Rate
GAIN = V CC (high gain)
LSB OFF Input Offset (Note 5) -0.5 0.5
dB 35.5 37 SINAD
Signal-to-Noise Plus Distortion
Ratio
Bits
5.85 ENOB L
5.8 ENOB H
(Note 6)
(Note 6)
ns 1 t SKEW Data Valid Skew
ns 3.0 t PD
Clock to Data Propagation
Delay
UNITS MIN TYP MAX SYMBOL PARAMETER
TNK+ to DCLK (Note 6) ns 4.5 t DCLK Input to DCLK Delay
Figure 8 ns 5.5 t AD Aperture Delay
Figure 8
clock
cycle
1 PD Pipeline Delay
TIMING CHARACTERISTICS (Data outputs: R L = 1M Ω , C L = 15pF)
DYNAMIC PERFORMANCE (Gain = open, external 90MHz clock (Figure 7), V IN = 20MHz sine, amplitude -1dB below
full scale, unless otherwise noted.)