Rainbow Electronics MAX5351 - Manual (Page 2)

MAX535/MAX5351
Low-Power, 13-Bit Voltage-Output DACs
with Serial Interface
2 _______________________________________________________________________________________
ABSOLUTE MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS: MAX535
(V DD = +5V ±10%, REF = 2.5V, GND = 0V, R L = 5k
Ω
, C L = 100pF, T A = T MIN to T MAX , unless otherwise noted. Typical values are at
T A = +25°C. Output buffer connected in unity-gain configuration (Figure 8).)
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
V DD to GND .................................................................-0.3V, +6V
REF, OUT, FB to GND ................................-0.3V to (V DD + 0.3V)
Digital Inputs to GND ...............................................-0.3V to +6V
Continuous Current into Any Pin.......................................±20mA
Continuous Power Dissipation (T
A = +70°C)
Plastic DIP (derate 6.90mW/°C above +70°C) .................552mW
µMAX (derate 4.00mW/°C above +70°C) ......................330mW
CERDIP (derate 8.00mW/°C above +70°C) ...................640mW
Operating Temperature Ranges
MAX535_C_A/MAX5351_C_A...............................0°C to +70°C
MAX535_E_A/MAX5351_E_A ............................-40°C to +85°C
MAX535BMJA/MAX5351BMJA .......................-55°C to +125°C
Storage Temperature Range .............................-65°C to +150°C
Lead Temperature (soldering, 10sec) .............................+300°C
Code dependent, minimum at code 1555 hex
4.5V
≤
V DD
≤
5.5V
MAX535MJA
CONDITIONS
k
Ω
14 20 R REF Reference Input Resistance
V 0 V DD - 1.4 V REF Reference Input Range
µV/V PSRR Power-Supply Rejection Ratio 600
±0.5
Bits 13 N Resolution
ppm/°C 1 Gain-Error Tempco
LSB GE Gain Error (Note 1) -0.5 ±6
ppm/°C 6 TCV OS Offset-Error Tempco
LSB ±1.0 INL
Integral Nonlinearity
(Note 1)
±2.0
±0.3 ±8 mV V OS Offset Error
UNITS MIN TYP MAX SYMBOL PARAMETER
MAX535A
MAX535B
Guaranteed monotonic LSB ±1.0 DNL Differential Nonlinearity
V REF = 0.67Vp-p kHz 650 Reference -3dB Bandwidth
Input code = all 0s, V REF = 3.6Vp-p at 1kHz
V REF = 1Vp-p at 25kHz, code = full scale dB 77 SINAD
Signal-to-Noise Plus
Distortion Ratio
dB -84 Reference Feedthrough
V 2.4 V IH Input High Voltage
V IN = 0V or V DD
pF 8 C IN Input Capacitance
µA 0.001 ±0.5 I
IN
Input Leakage Current
V 0.8 V IL Input Low Voltage
STATIC PERFORMANCE—ANALOG SECTION
DIGITAL INPUTS
REFERENCE INPUT
MULTIPLYING-MODE PERFORMANCE