BabyTrend WK10980 - TREND WALKER - HELLO KITTY - Manual (Page 4)

Copyright © 2011, Baby Trend Inc., All Rights Reserved. Copyright © 2011, Baby Trend Inc., All Rights Reserved.
6 5
PlACING ChIld IN The WAlkeR
Always check the walker prior to each use to ensure that the seat is
snapped in place and that the walker has no loose or broken parts. Do
not use the walker if it is damaged or broken or missing parts.
Before placing your child in the walker, please determine that your
child is developmentally ready for this type of product. generally, your
child must be able to sit upright unassisted and have adequate neck
strength to exhibit very good control of his or her head. Typically, a
child should be at least 6 months of age to use this product. Infants
develop at different rates and you should discuss the use of a
walker with your pediatrician to ensure that your infant is ready.
Adjust the seat height of the walker to the lowest setting. Place your
child in the walker and check that both feet touch the floor. The child
should have only part of their weight on their feet when their legs are
straight. Adjust the walker height as needed as your child grows. Do
not adjust height with child in the walker. Discontinue using the walker
if your child attempts to climb out, reaches 30 pounds in weight or 32
inches in height, or when your child is able to walk unassisted.
The baby walker can be used for 3 different heights. To adjust height, remove
baby from walker. Turn the safety button lengthwise and press the safety
button until the mechanism is released. Adjust to desired height (fig. 10)
WARNING:
TO ReduCe ChANCe Of ChIld SlIPPING
OuT Of The SeAT, CheCk ThAT BOTh feeT Of The ChIld
TOuCh The flOOR. NeVeR CARRy WAlkeR WITh The
ChIld IN IT, AS The ChIld mAy GeT huRT OR SlIP OuT.
when the position has been selected, check that the safety button
turned through 90 degrees to prevent the accidental release of the
mechanism. (fig. 11) Always follow this procedure. never use the
baby walker if the button is not in the sideways position. Important:
never change the height when the baby is in the walker.
Thread the end of the support strap through
the loop on the seat bottom and then through
the slot at the end of the height adjustment
bracket found under the tray. (fig. 8)
next thread the support strap through
the opening in the rectangular
ring and pull snug. (fig. 9)
To attach the toy bar, clip the hooks on
both sides of the toy bar to the walker
tray. (fig. 10) Do not use the toy bar
if it has been damaged or broken.
TO fOld WAlkeR
To fold the walker, turn the button to unlock
and push it to release. Then push the tray
downward to the lowest position. (fig. 11)
8)
ASSEMBLY
fig. 8
Clip on
OPERATION
COmPleTed WAlkeR
1)
2)
3)
4)
5)
fig. 9
fig. 10
fig. 11
9)
10)
11)