BabyTrend 1305R - SNAP-N-GO - Manual (Page 4)

• To attach the parent tray, position the tray so that the hinges for the
storage compartment are facing foward. Attach one end at a time by
locating the fitting at the top of the frame and the hole on the side
of the parent tray, snap together. Repeat for other side. Check that
the tray is securely latched in place. Please see figure 4. To remove
parent tray, reverse the installation steps.
WARNING:
Do not place hot
liquids in the parent tray. Hot liquids can
burn your child. Do not place more than
3 pounds in the tray as it may cause a
hazardous unstable condition to exist.
WARNING:
Avoid serious injury
from falling or sliding out. Always use the
Infant Car Seat harness
.
BRAKES
WARNING:
Always set brakes
when the stroller is not being pushed so that
the stroller will not roll away. Never leave
stroller unattended on a hill or incline as the
stroller may slide down the hill.
• To engage brakes, apply light downward pressure to the brake lever
located on each rear wheel. The stroller may require slight forward
or rearward movement in order to line up the teeth on the brake
with the each wheel brake cluster. See figure 5. Check that the
stroller will not move and that the brakes are properly applied. To
release, gently lift up on the brake lever.
TO FOLD STROLLER:
Do Not allow children near stroller while folding.
• To fold the stroller slide the red handle in the center of the handle to
the left and squeeze while pushing forward on the handle. Once the
stroller begins to fold, release the red handle and pull backward on
the front frame until stroller is folded. Please see figure 6. Secure
the stroller in the folded position by latching the fold latch, located
on the right side of the stroller at the intersection of the handle
and the rear tube, over the extended rivet on the lower frame tube.
Please see figure 7.
Figure 4.
Figure 5.
Figure 6.
Figure 7. Figure 8.
LOCK UNLOCK
3